I.  Tagging (Recording) and Shimming Measured Components............................................... 502

Page TC-4
Apr 1/05
20-00-02/70-00-01
Copying, use or disclosure of information on this page is subject to proprietary restrictions.
SECTION  PAGE
2. Packing and Seals ....................................................................................................................... 502

A.  Lubricating and Installing Packings....................................................................................... 502

B.  Heat-set Seal Installation....................................................................................................... 504

C.  Forming Lip Seals.................................................................................................................. 504

3. Conical Seal................................................................................................................................. 505

A.  Conical Seal Selection and Lubrication................................................................................. 505

B.  Conical Seal Installation ........................................................................................................ 505

4. Pressing Interference Fit Parts .................................................................................................... 507

A.  Cold Soaking Loose Tolerance Fit Parts............................................................................... 507

B.  Heating Close Tolerance Fit Parts. ....................................................................................... 507

C.  Press Fitting Assembly Parts Using an Arbor Press.............................................................507

D.  Force Forming Gearshaft Assembly Retainer Rings ............................................................ 507

5. Torque Requirements .................................................................................................................. 509

A.  General Torque Requirements..............................................................................................509

B.  Procedure- Preparing and Installing Fasteners (Standard Shop Practice)..........................511

C.  Guideline - Assembly Torque Values (Nuts, Bolts, Screws, Studs, and Inserts).................. 515

D.  Procedure - Preparing and Installing Fluid and Gasketed Fittings, and Special Metal and Conical Seals for Tubing and Hose Fittings. ......................................................................... 518
E.  Procedure -Preparing and Installing O-rings on Fittings ...................................................... 525

F.  Procedure -Preparing and Installing Universal Fittings........................................................526

G.  Procedure -Preparing and Installing Bulkhead Fittings........................................................527

6. Lockwire Installation and Techniques..........................................................................................528

A.  General..................................................................................................................................528

B.  Lockwiring Examples.............................................................................................................528

7. Cotter Pins and Key Washers......................................................................................................530

A.  Cotter Pin Installation ............................................................................................................ 530

B.  Cotter Key Installation ........................................................................................................... 531
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：標準施工手冊 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(11)