曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Table 505. Bolts and Nuts with Metal-to-Metal Faying Surfaces ........................................................... 513
Table 506. Minimum Torque in Inch-Pounds ......................................................................................... 514
Table 507. Examples - 77,500 psi Thread Root Stress ......................................................................... 516
Table 508. Examples - 62,000 psi Thread Root Stress ......................................................................... 516
Table 509. Examples - 41,875 psi Thread Root Stress ......................................................................... 517
Table 510. Flared Tubing and Hose Fittings Tightening Specifications................................................. 520
Table 511. Gasketed Fittings in Low Temperature Alloys - EZ33A-T5.................................................. 521
Table 512. Gasketed Fittings in Low Temperature Alloys - AZ91G-T6 ................................................. 522
Table 513. Dynamic Beam Seal Tubing and Fittings.............................................................................523
Table 514. Coupling Nuts, Flareless Tube............................................................................................. 524
Table 701. Inch Fraction, Decimal, Millimeter Equivalent......................................................................703
Table 702. Drill Size Decimal Equivalent ............................................................................................... 704
Table 703. Fahrenheit to Centigrade/Celsius Conversion ..................................................................... 705
Table 704. Centigrade/Celsius to Fahrenheit Conversion ..................................................................... 715
Table 705. Equipment and Manufacturer List ........................................................................................ 725
Table 706. Consumables and Manufacturers List ................................................................................. 727
Table 707. List of Specifications ............................................................................................................ 734

Page TC-11
Apr 1/05
20-00-02/70-00-01
Copying, use or disclosure of information on this page is subject to proprietary restrictions.

PAGE INTENTIONALLY LEFT BLANK

Page TC-12
Apr 1/05
20-00-02/70-00-01
Copying, use or disclosure of information on this page is subject to proprietary restrictions.
INTRODUCTION
1. General
Information provided in this manual pertains to overhaul and repair processing for parts
manufactured by Honeywell Engines, Phoenix, Arizona.

Specific instructions and authority for applying processes to parts are covered in applicable Overhaul Manuals, Component Maintenance Manuals, Inspection/Repair Manuals, Workscope Planning Guides, Repair Manuals, and Maintenance Manuals for the unit in work.  The procedures in this manual should only be used when specifically referenced from one of these manuals.  If data contained in a manual covering a specific unit conflict with data contained in this manual, the manual covering the specific unit will take precedence.
Layout of this manual generally follows Air Transport Association Specification No. 100 as reflected in the Table of Contents.
Equipment, consumables, and specifications referenced in the text (SECTION VII) are listed in SECTION VII Appendix, along with the manufacturers names and addresses.  Specific methods are referenced in the text as shown in the following examples:  (Method No. 203C indicates a specific cleaning method), (Method No. 405B indicates a specific repair method). Refer to the Table of Contents for chapter indicated.
Introduction Page 1 Apr 1/05
20-00-02/70-00-01
2. Abbreviations and Definitions
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：標(biāo)準(zhǔn)施工手冊 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(16)