曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Part-M  AMC to Appendix V
AMC to Appendix V to Part-M Maintenance Organisation Approval referred to in Annex I (Part-M) Subpart F
The following fields on page 2 “Maintenance Organisation Approval Schedule” of the maintenance organisation approval certificate should be completed as follows:
–  
Date of original issue: It refers to the date of the original issue of the maintenance organisation manual

–  
Date of last revision approved: It refers to the date of the last revision of the main-tenance organisation manual affecting the content of the certificate. Changes to the maintenance organisation manual which do not affect the content of the certificate do not require the reissuance of the certificate.

–  
Revision No: It refers to the revision No of the last revision of the maintenance organ-isation manual affecting the content of the certificate. Changes to the maintenance organisation manual which do not affect the content of the certificate do not require the reissuance of the certificate.

ED 2010/002/R
PART-M Appendices
Appendix VI
Continuing Airworthiness Management Organisation Approval referred to in Annex I (Part-M) Subpart G

[MEMBER STATE (*)]
A Member of the European Union (**)

CONTINUING AIRWORTHINESS MANAGEMENT ORGANISATION
APPROVAL CERTIFICATE

Reference: [MEMBER STATE CODE (*)].MG.XXXX (ref. AOC XX.XXXX)
Pursuant to Regulation (EC) No 216/2008 of the European Parliament and of the Council and to Commission Regulation (EC) No 2042/2003 for the time being in force and subject to the condi-tion specified below, the [COMPETENT AUTHORITY OF THE MEMBER STATE (*)] hereby certifies:
[COMPANY NAME AND ADDRESS]
as a continuing airworthiness management organisation in compliance with Section A, Subpart G of Annex I (Part-M) of Regulation (EC) No 2042/2003, approved to manage the continuing airworthiness of the aircraft listed in the attached schedule of approval and, when stipulated, to issue recommendations and airworthiness review certificates after an airworthiness review as specified in point M.A.710 of Annex I (Part-M), and, when stipulated, to issue permits to fly as specified in point M.A.711(c) of Annex I (Part-M) of the same regulation.
CONDITIONS
1.
This approval is limited to that specified in the scope of approval section of the approved con-tinuing airworthiness management exposition as referred to in Section A, Subpart G of Annex I (Part-M) of Regulation (EC) No 2042/2003.

2.
This approval requires compliance with the procedures specified in the Annex I (Part-M) to Regulation (EC) No 2042/2003 approved continuing airworthiness management exposition.

3.
This approval is valid whilst the approved continuing airworthiness management organisa-tion remains in compliance with Annex I (Part-M) to Regulation (EC) No 2042/2003.

4.
Where the continuing airworthiness management organisation contracts under its Quality System the service of an/several organisation(s), this approval remains valid subject to such organisation(s) fulfilling applicable contractual obligations.

5.
Subject to compliance with the conditions 1 to 4 above, this approval shall remain valid for an unlimited duration unless the approval has previously been surrendered, superseded, sus-pended or revoked. If this form is also used for AOC holders, the AOC number shall be added to the reference, in addition to the standard number, and the condition 5 shall be replaced by the following extra conditions:

6.
This approval does not constitute an authorisation to operate the types of aircraft referred in paragraph 1. The authorisation to operate the aircraft is the Air Operator Certificate (AOC).

7.
Termination, suspension or revocation of the AOC automatically invalidates the present approval in relation to the aircraft registrations specified in the AOC, unless otherwise explicitly stated by the competent authority.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS – PART M 2(29)