8.
Subject to compliance with the previous conditions, this approval shall remain valid for an unlimited duration unless the approval has previously been surrendered, superseded, sus-pended or revoked.

Date of original issue: ........................................................................................... Signed: .................................................................................................................... Date of this revision: .............................. Revision No: ...................................... For the Competent Authority: [COMPETENT AUTHORITY OF THE MEMBER STATE (*)]
Page … of …
EU 127/2010
Page 2 of 2.
CONTINUING AIRWORTHINESS MANAGEMENT ORGANISATION APPROVAL SCHEDULE
Reference: [MEMBER STATE CODE (*)].MG.XXXX
(ref. AOC XX.XXXX)

Organisation: [COMPANY NAME AND ADDRESS]
Aircraft type/series/ group  Airworthiness review authorised  Permits to fly authorised  Organisation(s) working under quality system 
[YES / NO] (***)  [YES / NO] (***) 
[YES / NO] (***)  [YES / NO] (***) 
[YES / NO] (***)  [YES / NO] (***) 
[YES / NO] (***)  [YES / NO] (***) 

This approval schedule is limited to that specified in the scope of approval contained in the
approved Continuing Airworthiness Management Exposition section ............
Continuing Airworthiness Management Exposition Reference: .......................
Date of original issue: ...........................................................................................
Signed: ....................................................................................................................
Date of this revision: .............................. Revision No: ......................................
For the Competent Authority: [COMPETENT AUTHORITY OF THE MEMBER STATE (*)]

EASA Form 14 Issue 3
(*) or EASA if EASA is the competent authority (**) Delete for non-EU Member State or EASA (***) Delete as appropriate if the organisation is not approved.
PART-M Appendices
EU 127/2010

ED 2010/002/R
AMC to Appendix VI to Part-M Continuing Airworthiness Management Organisation Approval referred to in Annex I (Part-M) Subpart G
The following fields on page 2 “Continuing Airworthiness Management Organisation Approval Schedule” of the continuing airwothiness management organisation approval certificate should be completed as follows:
–  
Date of original issue: It refers to the date of the original issue of the continuing airworthiness management exposition

–  
Date of last revision: It refers to the date of the last revision of the continuing air-worthiness management exposition affecting the content of the certificate. Changes to the continuing airworthiness management exposition which do not affect the content of the certificate do not require the reissuance of the certificate.

–  
Revision No: It refers to the revision No of the last revision of the continuing airwor-thiness management exposition affecting the content of the certificate. Changes to the continuing airworthiness management exposition which do not affect the con-tent of the certificate do not require the reissuance of the certificate.

Appendix VII
Complex Maintenance Tasks
The following constitutes the complex maintenance tasks referred to in M.A.502(d)3, M.A.801(b)2 and M.A.801(c):
1.  The modification, repair or replacement by riveting, bonding, laminating, or welding of any of the following airframe parts:
(a)  
a box beam;

(b)  
a wing stringer or chord member;

(c)  
a spar;

(d)  
a spar flange;

(e)  
a member of a truss-type beam;

(f)  
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS – PART M 2(30)