曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

03 (CA) JUN 02
 
3) Using a brush soaked with cleaning agent (TB 11-003), clean :
- elevator attachment point pin,
- elevator tab hinges.
4) Remove excess cleaning agent with a clean lintfree cloth.
5) Using a brush and grease (TB 04-004A), lubricate :
- elevator attachment point pin,
CAUTION : DO NOT LUBRICATE TAB HINGE PINS COATED WITH TEFLON FILM.
- elevator tab hinges.
6) Remove excess grease with a clean lintfree cloth.
7) Coat the interior of the balance weight tube with siccative oil (TB 05-914) - refer to 55-20-01.
8) Make sure all the tools and materials are removed and the work area is clean and free from debris.
9) Install the elevator - refer to 55-20-01.
10) Install tail cone 222 - refer to 53-20-04.
ABAA
Validity : S / N 1 - 9999 12-21-03Page 202
(CA) JUN 02
 
  A - Rudder control
B - Rudder tab control

O VA - GV
 TB04 - 004A

s POINT DE LUBRIFICATION LUBRICATION POINT
Area 300 lubrication - Rudder
Figure 201
ABAA
Validity : S / N 1 - 9999 12-21-03Page 203
(CA) JUN 02
 
 
 
I
TB04 - 004A
 /
11 POINT DE LUBRIFICATION
LUBRICATION POINT CAUTION : DO NOT LUBRICATE TAB HINGE PINS
COATED WITH TEFLON FILM. Area 300 lubrication - Elevator
Figure 202
ABAA
Validity : S / N 1 - 9999 12-21-03Page 204
(CA) JUN 02
 
AREAS 500 / 600 LUBRICATION
MAINTENANCE PRACTICES
1. AREAS 500 / 600 LUBRICATION
NOTE : This procedure is applicable to areas 500 and 600.
A. Tools and consumable materials
- Grease (TB 04-004A)
- Grease (TB 06-900)
- Clean lintfree cloths
- Brush
- Cleaning agent (TB 11-003)
B. Lubrication of wings / fuselage attachments (Figure 201)
1) Remove cowling under hull 218 - refer to 06-30-00.
2) Using a brush soaked with cleaning agent (TB 11-003), clean :
- front attachment,
- main attachment,
- rear attachment.
3) Remove excess cleaning agent with a clean lintfree cloth.
4) Using a brush and grease (TB 04-004A), lubricate :
- front attachment,
- main attachment,
- rear attachment.
5) Remove excess grease with a clean lintfree cloth.
6) Make sure all the tools and materials are removed and the work area is clean and free from debris.
7) Install cowling under hull 218 - refer to 06-30-00.
C. Lubrication of flight controls (Figures 202, 203 and 203A)
1) Remove cowling under hull 218 and inspection doors 512,612,516 and 616 - refer to 06-30-00. CAUTION : MAKE SURE THE FLAP AREA IS CLEAR.
2) Extend the flaps.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 12 SERVICING TB20飛機維護手冊 12 保養(yǎng)(63)