曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

2) Jack up the aircraft - refer to 07-10-00.
3) Remove the nose wheel - refer to 32-41-02.
4) Using a brush soaked with cleaning agent (TB 11-002), clean :
- nose wheel bearings,
- landing gear leg axle,
- rod ends and hinges of landing gear and landing gear steering system.
5) Remove excess cleaning agent with a clean lintfree cloth.
CAUTION : NEVER LUBRICATE GREASE FITTING ITEM "A", FIGURE 201, WITH A PNEUMATIC GREASE GUN.
6) Using a grease gun filled with grease (TB 04-004A), lubricate the three scissors grease fittings, the landing gear leg grease fitting, the strut grease fittings, if installed.
7) Remove excess grease with a clean lintfree cloth.
8) Visually check the wheel bearing condition, lubricate them with grease (TB 04-004A).
9) Remove excess grease with a clean lintfree cloth.
10) Using a brush and grease (TB 04-004A), lubricate :
- rod ends and hinges of landing gear and landing gear steering system,
- strut spring.
11) Remove excess grease with a clean lintfree cloth.
12) Make sure all the tools and materials are removed and the work area is clean and free from debris.
ABAA
Validity : S / N 1 - 9999 12-21-05 Page 201
(CA) JUN 02
 
13) Install the nose wheel - refer to 32-41-02.
14) Lower the aircraft to ground and remove the jacks - refer to 07-10-00.
15) Make sure all the tools and materials are removed and the work area is clean and free from debris.
16) Remove the engine cowlings - refer to 71-10-01.
C. Lubrication of main landing gear and doors (Figures 204 and 205)
1) Jack up the aircraft - refer to 07-10-00.
2) Remove the main landing gear wheels - refer to 32-41-01.
3) Install a drip pan under the landing gear leg.
4) Protect the chromium-plated section of the shock-absorber with clean cloths.
5) Using a compressed air gun set to a maximum pressure of 29 psi (2 bars) and using cleaning agent (TB 11-002), clean :
- landing gear leg, actuator, strut and shock-absorber,
- landing gear box,
- doors and their rods and attachments.
6) Remove excess cleaning agent with a clean lintfree cloth and dry with compressed air.
7) Using a brush soaked with cleaning agent (TB 11-002), clean :
- main landing gear wheel bearings,
- landing gear leg axle.
Post-MOD. 151
8) Manually unlock the footstep to clean, using a brush soaked with cleaning agent (TB 11-002) :
- cable end,
- control bellcrank,
- cable.
S / N 1 - 9999
9) Remove excess cleaning agent with a clean lintfree cloth.
CAUTION : PROGRESSIVE LUBRICATION OF SHOCK-ABSORBER HINGE GREASE FITTING WITHOUT ANY VIOLENT JERKS.
10) Lubricate the two grease fittings located on shafts from landing gear to wings using a grease pump and grease (TB 04-004A), the grease fittings of strut (if installed), articulated arm and shock-absorber hinges.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 12 SERVICING TB20飛機維護手冊 12 保養(65)