Page 1003
25-26-87
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
Table 1001 (Continued)
Troubleshooting Procedures
FAULT PROBABLE CAUSE AND FAULT ISOLATION CORRECTIVE ACTION
Leveling screws not properly adjusted a. Leave foodtray assembly in vertical position and locate leveling adjustment screw. This screw is located at the bottom of the slide plate assembly just below and to the left of the set screw slide plate assembly, just below and to the left of set screw attaching foodtray assembly to forward pivot assembly.
b. Adjust leveling adjustment screw in or out until foodtray assembly is level (180°) with cocktail table.
Foodtray leaf hinge(s) broken Replace foodtray leaf hinge(s).
Friction bushings adjusted too tightly Adjust friction bushings so that headrest slide plate assembly slides on easily.
IN-ARM FOODTRAY NOT LEVEL (FRONT-TO-BACK)
FOODTRAY INNER AND OUTER LEAF ASSEMBLIES BROKEN AT HINGE
HEADREST IS DIFFICULT TO INSTALL
HEADREST EARS ARE DIFFICULT TO BEND
HEADREST FORWARD TILT TOO LOOSE OR TOO TIGHT
LIFE VEST SHROUD ASSEMBLY ACCESS DOOR WILL NOT OPEN AND CLOSE PROPERLY
LIFE VEST SHROUD ASSEMBLY ACCESS DOOR LOOSE
NOTE: The headrest slide plate assembly locking nut located on the headrest assembly should be properly torqued so that the headrest can be consistently moved by a force between
10-12 LB.
1/4 - 28 hex head bolt and Torque to allow headrest ear to be
locking nut over-torqued consistently moved with 8-10 pounds of
force exerted at the end of the ear.
Pivot bolt and nut under- or Torque to allow forward tilt pressure of 8-10
over-torqued LB.
Pull latch broken or Replace pull latch and mounting screws.
defective
Loose screws on hinge Replace loose screws on hinge assembly.
assembly
Page 1004
25-26-87
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
Table 1001 (Continued)
Troubleshooting Procedures
FAULT PROBABLE CAUSE AND FAULT ISOLATION CORRECTIVE ACTION
SEAT BACK WILL NOT RECLINE 1. Recline control cable assembly loose from actuator end of recline lock 2. Recline control cable out of cable lever slot in seat control assembly 3. Recline control cable assembly broken a. Inspect recline lock actuator to see whether control cable has slipped out of actuator slot or actuator has slipped off recline lock. b. Reinstall cable to actuator slot or actuator to hydrolok. c. If problem persists, go to step 2. a. Remove the (2) screws attaching seat control bezel to endbay assembly. b. Replace control cable into cable lever slot and test for proper operation. c. If problem persists, go to step 3. a. Replace control cable assembly. b. Adjust cable tension. c. Test recline control button for proper recline operation. d. If problem persists, go to step 4.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(10)
