Table 1001 (Continued)
Troubleshooting Procedures

PROBABLE CAUSE AND FAULT
FAULT ISOLATION CORRECTIVE ACTION
4. Lumbar valve tube
a. Remove O-ring attaching lumbar valvebroken/ defective
    tube to inflatable lumbar cushion.
b.
 Install replacement lumbar valve    assembly.

c.
Install lumbar control cable to lumbar     valve assembly.

d.
 Test for proper operation.

e.
 If problem persists, go to step 5.

5. Lumbar cushion
a. Replace lumbar cushion assembly. assembly defective
b. Test for proper operation.
NOTE:  Refer to REPAIR (Page Block 6000) for more detailed instructions on removal and installation of seat control components.
NOTE: For troubleshooting electronic customer-furnished equipment, please refer to the appropriate vendor-furnished maintenance documentation.
Page 1008
25-26-87
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

SCHEMATIC AND WIRING DIAGRAMS
1.  General
NOTE:  Refer to the customer-furnished equipment maintenance documentation for appropriate troubleshooting and maintenance of customer-furnished electronics and electrical equipment used within these B/E Aerospace seating products.
A. Cable Routing
This section contains installation, maintenance and service procedures for properly routing and securing electrical cables on aircraft seating equipment. These general practices apply to all series of aircraft passenger seats manufactured by B/E Aerospace. Refer to aircraft manufacturer’s specifications for OEM requirements and more detail. For example:
OEM Specification  Document
Boeing  Electrical Bonding  BAC5117 
Installation of Electrical Wiring  BAC5158 

(1)  Routing Principles
(a)  
Cables shall be as accessible as possible to allow for ease of maintenance and inspection since most repairs are carried out on the aircraft.

(b)  
Route cables to avoid possible damage from passenger contact, underseat carry on storage and shifting, spills, and/or mechanical movement of seat components. Refer to Figure 2001.

Page 2001
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL MILLENNIUM. 88813 SERIES
RECLINE MECHANISM STRUCTURE

Figure 2001
(c)  When seat parts can rotate between each other, route the cables parallel to the rotation axis. Refer to Figure 2002.

Figure 2002
Page 2002
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

(d)  
Route cables to minimize the need for protective methods and materials like wrap or sleeves.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(12)