Page 5003
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
THIS PAGE IS INTENTIONALLY LEFT BLANK.
Page 5004
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
REPAIR
1. General
Common repair procedures for seating products typically involve replacement of high-wear, aesthetic components, such as armcaps, cushion covers, and shrouds. Removal and installation of many of these parts may be accomplished using DISASSEMBLY (Page Block 3000) and ASSEMBLY (Page Block 7000) or by referring to the figures in the Illustrated Parts List.
This section describes tasks that may require an additional amount of procedural information.
Table 6001
Repair Tasks
A Repair Damaged Surfaces
B Remove, Install, and Adjust Headrest and Headrest Ear Assemblies
C Remove and Install Lumbar Valve Tube
D Remove and Install Legrest Gas Lock
E Remove and Install Recline Control Hydraulic Lock and Adjust Back Recline
F Remove and Install Seat Control Cable Assemblies
G Remove and Install Seat Recline Control Cable
2. Procedures
A. Repairing Damaged Surfaces
(1)
Minor surface damage (Light alloy and steel components)
(a)
Blend out minor surface damage using an abrasive cloth. NOTE: Minor surface damage is considered to be abrasions and scratches.
(b)
If applicable, restore the surface treatment in accordance with local regulations.
(2)
Minor surface damage (Thermoformed plastic panels)
(a)
Clean plastic surface with alcohol or an alphatic solvent such as mineral spirits, heptane, or hexane.
(b)
Fill any surface irregularities with catalyzed polyester resin filler.
NOTE: Catalyze only the amount of filler that will be used immediately because the material will begin to harden within five minutes. An automotive body repair surfacing putty may be used as a fill material.
Page 6001
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL MILLENNIUM. 88813 SERIES
(c)
Level with spatula before filler hardens and restore texture by stippling with a stiff-bristle brush.
(d)
After filler has fully hardened (10 to 15 minutes), rub the area lightly with an abrasive cloth to blend repair into adjacent areas.
(3)
Screw threads
(a)
Slightly rough or burred threads may be cleaned up using a thread file or small three-corner file on external threads and a plug tap of correct size for internal threads.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(31)
