国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽

  • 熱門標簽

當前位置: 主頁 > 航空資料 > 國外資料 >

時間:2010-05-10 17:38來源:藍天飛行翻譯 作者:admin
曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

the coefficient of lift increases, lift also will increase.
The coefficient of lift goes up as the angle of attack
is increased. As air density increases, lift increases.
However, you will usually be more concerned with
2-6
how lift is diminished by reductions in air density on
a hot day, or if you are operating at higher altitudes.
All wings produce lift in two ways:
1. Airfoil shape creating a higher velocity over
the top of the wing and a lower velocity over
the bottom of the wing with Bernoulli’s venturi
effect.
2. Downward deflection of airflow because of
the curvature of the wing with the principle of
Newton’s Third Law of Motion: For every action,
there is an equal and opposite reaction.
Both principles determine the lifting force. Review
Chapter 2 in the Pilot’s Handbook of Aeronautical
Knowledge to understand Newton’s laws of motion
and force and Bernoulli’s principle of pressure.
Drag
Drag is the resistance to forward motion through the
air. Drag opposes thrust. Aerodynamic drag comes in
two forms:
1. Induced drag: a result of the wing producing lift;
2. Parasite drag: resistance to the airflow from
the cart, its occupants, suspension lines from
the wing, interference drag from objects in the
airstream, and skin friction drag of the wing.
Induced drag is the result of lift, and its amount varies
as discussed above for lift. Induced drag creates
organized circular vortices off the wing tips that generally
track down and out from each wingtip. [Figure 2-
12] This is true for all aircraft that use wings including
PPC, weight-shift control and fixed wing aircraft. The
bigger and heavier the aircraft, the greater and more
powerful the wingtip vortices will be. This organized
swirling turbulence is an important factor to understand
for flight safety. Refer to Section 7-3 of the Aeronautical
Information Manual (AIM) or Chapter 12 of the
Pilot’s Handbook of Aeronautical Knowledge (FAA-H-
8083-25) for additional discussion.
Parasite drag is caused by the friction of air moving
over the structure. Just as with lift, parasite drag increases
as the surface area of the aircraft increases
and dramatically increases as airspeed increases,
at the square of the velocity. Therefore, doubling
the airspeed will quadruple your parasite drag.
[Figure 2-13]
The PPC has relatively slow speeds, but plenty of
items (area) for the wind to strike including wing,
lines, pilot, cart, engine, wheels, and tubes. Parasitic
drag can be reduced by streamlining the items but
since the PPC flies at relatively slow airspeeds, the
extra weight, cost, and complexity of streamlining the
PPC is generally not incorporated into the design.
Total Drag is the combination of parasite and induced
drag. Total Drag = Parasitic Drag + Induced Drag
To help explain the force of drag, the mathematical
equation D = Cd · q · S is used. In this equation drag
(D) is the product of drag coefficient (Cd), dynamic
pressure (q) determined by the velocity squared times
the air density factor, and surface area (S) of the cart
and the ram-air wing (S). The drag coefficient is the
ratio of drag pressure to dynamic pressure.
Figure 2-12. Turbulence —
induced drag wingtip vortices
— created by lift of the ram-air wing.
Figure 2-13. Frontal areas of the cart, wing, and occupants
are the source of parasitic drag.
2-7
Induced and parasitic drag have opposite effects as
angle of attack decreases and speed increases. Note
the total drag. It is high at the slowest air speeds at
high angles of attack near the stall, decreases to the
lowest at the most efficient airspeed, and then progressively
increases as the speed increases. The PPC
wing is typically designed to fly at a speed generally
above lowest overall total drag. Too slow, and the
wing would be near its critical angle of attack. Too
fast, and the power to maintain level flight or climb
would be excessive. The manufacturer determines the
speed range of the wing based on the weight range,
and the resultant location on the total drag diagram.
[Figure 2-14]
Figure 2-14. Relationship between drag and speed.
are very similar to those for an airplane or gliding
sailplane. [Figure 2-15] Specific numbers presented
in this chapter are examples to serve as a basis to
understand the concepts. Each PPC has unique flying
characteristics and these numbers will be different,
but can be compared to your PPC to provide a
greater understanding of your unique performance.
 
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址:Powered Parachute Flying Handbook動力傘飛行手冊(15)
国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽
日本三级中国三级99人妇网站| 久久久成人av| 99久久久精品视频| 国产精品视频一区二区三区四 | 国产一区二区四区| 日韩在线免费视频观看| 亚洲在线免费看| 国产日本欧美一区二区三区 | 日韩av不卡电影| 久久综合精品一区| 欧美激情一区二区三区久久久| 免费看a级黄色片| 国产精品久久久久免费| 欧美在线欧美在线| 深夜福利一区二区| 欧美在线亚洲在线| 日韩在线视频免费观看高清中文| 少妇高清精品毛片在线视频| 国产精品一区视频网站| 不卡毛片在线看| 国产自偷自偷免费一区| 国产精品久久久久免费a∨ | 日韩亚洲在线观看| 欧美专区日韩视频| 国产福利视频在线播放| 日韩av日韩在线观看| 7777精品伊久久久大香线蕉语言| 亚洲制服中文| 91精品国产综合久久香蕉| 亚洲欧洲精品在线| 久久天天狠狠| 秋霞午夜一区二区| 久久精品在线视频| 欧美精品国产精品久久久| 久久精品国产成人| 欧美国产综合在线| 国产精品乱子乱xxxx| 国产中文字幕在线免费观看| 欧美成人免费在线观看| 国产一区二区三区小说| 一区二区三区日韩视频| 97国产一区二区精品久久呦| 成人做爰www免费看视频网站| 久久青草福利网站| 青草青草久热精品视频在线观看| 国产精品偷伦免费视频观看的| 国内精品模特av私拍在线观看| 久久综合伊人77777| 成人在线观看毛片| 日本一区精品| 国产成人三级视频| 国产日韩亚洲欧美| 亚洲最新免费视频| 久久av二区| 欧美日本国产精品| 精品国产第一页| 国产精品12345| 欧美日韩精品免费观看| 久久亚洲电影天堂| 国产精品444| 美国av一区二区三区| 亚洲欧洲日本国产| 久久九九亚洲综合| y111111国产精品久久婷婷| 日本高清一区| 精品国产免费人成电影在线观... 精品国产免费一区二区三区 | 久久久女人电视剧免费播放下载| 欧美在线视频导航| 在线视频亚洲自拍| 久久99精品国产99久久| 精品一区二区视频| 日韩在线第三页| 国产精品久久亚洲7777| 国产精品a久久久久久| 国产精品成人一区二区三区 | 日韩免费一区二区三区| 精品国产一区二区三区麻豆小说| 国产mv久久久| 欧美精品久久久久久久久| 久久久久久国产精品一区| 视频在线一区二区三区| 亚洲综合自拍一区| 欧美丰满熟妇xxxxx| 一区二区三区四区不卡| 日韩中文字幕视频| 成人9ⅰ免费影视网站| 日本久久亚洲电影| 欧美激情二区三区| 久久精品小视频| www.日日操| 国产在线视频91| 日韩av影视| 伊人久久青草| 国产精品久久久久久久久久东京 | 国产一区二区三区四区五区加勒比| 三年中国中文在线观看免费播放| 国产精品对白刺激| 久久久久久久久久久免费| 91免费视频国产| 免费毛片网站在线观看| 日韩精品 欧美| 欧美一区二区三区免费视| 久久69精品久久久久久久电影好| 久久久精品国产网站| 久久露脸国产精品| 91精品国产91久久久久| 国产精品揄拍500视频| 免费在线精品视频| 欧洲精品久久| 日韩精品一区二区三区电影| 午夜欧美一区二区三区免费观看| 九色91av视频| 久久成人在线视频| 国产精品无码专区av在线播放| 97成人在线视频| www.浪潮av.com| 国产精品一国产精品最新章节| 国产主播欧美精品| 国产一区免费在线观看| 精品一区二区三区自拍图片区| 免费高清在线观看免费| 黄色一级免费大片| 国内免费精品永久在线视频 | 国产在线视频在线| 国产一区二区高清视频| 蜜桃视频在线观看91| 男人添女人下部视频免费| 欧美在线观看黄| 狠狠综合久久av| 免费毛片一区二区三区久久久| 国产综合av在线| 国产色一区二区三区| 国产日韩视频在线观看| 国产欧美精品一区二区三区 | 亚洲一区免费网站| 亚洲日本精品一区| 欧美激情视频给我| 在线免费一区| 亚洲精品久久区二区三区蜜桃臀| 亚洲www在线观看| 日韩av三级在线| 欧美亚洲伦理www| 黄色一级片在线看| 国产免费一区二区| 国产精品最新在线观看| 97人人模人人爽人人少妇| 国产精品1234| 日韩亚洲欧美中文高清在线| 久久综合伊人77777蜜臀| 国产精品国模大尺度私拍| 久久99精品久久久久久青青91| 操人视频在线观看欧美| 亚洲一二三区精品| 日韩av在线综合| 欧美 日韩 国产在线| 国产欧美一区二区三区不卡高清 | 国产精品av在线| 国产精品入口免费| 在线国产99| 日韩av高清在线播放| 欧美韩国日本在线| 成人久久久久爱| 国产成人精品久久二区二区 | 国产精品免费一区二区三区| 国产区亚洲区欧美区| 91黄在线观看| 国产精品视频xxxx| 欧美激情在线观看视频| 日本一区二区在线免费播放| 欧美精品一区免费| 成人欧美一区二区| 日韩一区二区久久久| 欧美日韩不卡合集视频| 日韩免费精品视频| 国产免费毛卡片| 久久久久久久久一区二区| 国产精品国色综合久久| 亚州av一区二区| 欧美日韩亚洲在线| 99电影网电视剧在线观看| 久久九九有精品国产23| 一本色道久久99精品综合 | 欧美精品videofree1080p| 日韩在线综合网| 国模私拍视频一区| 久久偷窥视频| 精品乱色一区二区中文字幕| 亚洲欧美在线网| 黄色一级片黄色| 国产成人一区二| 久久69精品久久久久久久电影好| 日韩女优在线播放| 99国产盗摄| 欧美大肥婆大肥bbbbb| 国产成人福利视频| 中国成人亚色综合网站| 男人亚洲天堂网| 久久久久久久999精品视频| 亚洲熟女乱色一区二区三区 | 国产日韩av高清|