曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Section 11-31
Interior Placards and Markings - TAE 125 Diesel Engine
1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
AIRCRAFT
Placards and Markings DA 40 Series
AMM
Page 2
20 Sep 2007 11-CONTENTS Doc # 6.02.01
Rev. 5
Intentionally left blank
AIRCRAFT
DA 40 Series
AMM
Placards and Markings
Doc # 6.02.01
Rev. 5 11-00-00 Page 1
20 Sep 2007
CHAPTER 11
PLACARDS AND MARKINGS
1. General
Placards are used for identification and indication. They show the function, operation and operating
limitations of systems and equipment.
% Note: Placards must not be removed, exchanged or altered unless approved by the
% national airworthiness authority.
This Chapter shows you the location of these placards and markings:
) Exterior placards.
) Exterior markings.
) Interior placards.
Self-adhesive plastic foil is used for all placards except for the manufacturer's placard. Metal makes
the manufacturer's placard which is located on the vertical stabilizer, lower left side.
Replace damaged placards.
2. Replace Plastic Foil Placards
A. Material
Item Quantity Part Number
Solvent. A/R Commercial
B. Replace a Placard
Detail Steps/Work Items Key Items/References
(1) Remove the old placard:
S Heat the placard with a hot air blower.
S Lift one corner of the placard.
S Pull the placard off.
WARNING: DO NOT GET SOLVENT ON YOUR SKIN. DO NOT BREATH
SOLVENT VAPOR. SOLVENT CAN CAUSE OR ILLNESS.
AIRCRAFT
Placards and Markings DA 40 Series
AMM
Detail Steps/Work Items Key Items/References
Page 2
20 Sep 2007 11-00-00 Doc # 6.02.01
Rev. 5
(2) Clean the surface where the new placard will go. Use a commercial solvent. There must
be no dirt or grease on the surface.
Obey the solvent manufacturer's
instructions.
(3) Remove the protective backing from the new
placard.
(4) Put the new placard in the correct position. Make
the placard smooth with a clean cloth.
AIRCRAFT
DA 40 Series
AMM
Placards and Markings
Doc # 6.02.01
Rev. 5 11-20-00 Page 1
20 Sep 2007
Section 11-20
Exterior Placards and Markings - Lycoming Engine
1. General
Figure 1 shows the exterior markings and placards for the DA 40 with the Lycoming engine installed.
Figure 1: Exterior Placards - Airplanes with the Lycoming Engine Installed.
AIRCRAFT
Placards and Markings DA 40 Series
AMM
Page 2
20 Sep 2007 11-20-00 Doc # 6.02.01
Rev. 5
Intentionally left blank
AIRCRAFT
DA 40 Series
AMM
Placards and Markings
Doc # 6.02.01
Rev. 5 11-21-00 Page 1
20 Sep 2007
WARNING
APPROVED FUEL:
JET A-1
or see Airplane Flight Manual
Section 11-21
Exterior Placards and Markings - TAE 125 Diesel Engine
1. General
Figure 1 shows the exterior placards and markings for airplanes with the TAE 125 Diesel engine
installed.
% In case of Diesel Fuel operation (MÄM 40-129) the fuel grade placard is located next to each of the
% two fuel filler necks.
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% On Airplanes with early serial numbers the placard may include „Diesel EN 590".
AIRCRAFT
Placards and Markings DA 40 Series
AMM
Page 2
20 Sep 2007 11-21-00 Doc # 6.02.01
Rev. 5
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% Figure 1: Exterior Placards and Markings - Airplanes with the TAE 125 Diesel Engine Installed
DA4-1123-10-02
DA4-1123-10-02
2.0 bar / 29 psi
2.5 bar / 36 psi
3 Off
Between the
Blades
OIL
Shell Helix Ultra
5W/30 synth.
API SJ/CF
or see Airplane Flight Manual
External Power Connection
CAUTION: 14V DC
Coolant
WARNING
JET A-1
APPROVED FUEL:
or see Airplane Flight Manual
WARNING
JET A-1
APPROVED FUEL:
or see Airplane Flight Manual
On the Fuel
cooler baffle:
AIRCRAFT
DA 40 Series
AMM
Placards and Markings
Doc # 6.02.01
Rev. 5 11-30-00 Page 1
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40系列AMM 1(62)