2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
 No specific access platform 3.6 m (11 ft. 10 in.)

 1EFF : ALL 1 12-11-28Page 325 1 1 May 01/05R 1 1 1CES 1

 B. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-11-28-650-001  General Refuel/Defuel Safety Procedures
 12-11-28-650-002  Refuel/Defuel Safety Procedures for use in the Hangar
 12-11-28-650-007  Use of Magnetic Level Indicators (MLI)
 12-32-28-281-001  Drain Water Content
 12-34-24-869-001  Aircraft Grounding for the Refuel/Defuel Operations
 24-41-00-861-002  Energize the Aircraft Electrical Circuits from the
 External Power
 24-41-00-862-002  De-energize the Aircraft Electrical Circuits Supplied
 from the External Power
 28-25-00-650-001  Pressure Defuel
 28-25-00-869-001  Fuel Transfer
 31-60-00-860-001  EIS Start Procedure
 31-60-00-860-002  EIS Stop Procedure
 12-11-28-991-001  Fig. 301 

R  **ON A/C 001-049, 052-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 12-11-28-991-002 **ON A/C 051-051, Fig. 302
 12-11-28-991-002-A **ON A/C ALL Fig. 302A
R  12-11-28-991-004 Fig. 303 3. Job Set-up__________ (Ref. Fig. 301/TASK 12-11-28-991-001) **ON A/C 001-049, 052-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 (Ref. Fig. 302/TASK 12-11-28-991-002)

 **ON A/C 051-051,

 (Ref. Fig. 302A/TASK 12-11-28-991-002-A)
 **ON A/C ALL

 (Ref. Fig. 303/TASK 12-11-28-991-004) R **ON A/C 001-049, 052-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 Subtask 12-11-28-941-052
 A. Safety Precautions
 (1)
 You must obey the refuel/defuel safety precautions (Ref. TASK 12-11-28-650-001) (Ref. TASK 12-11-28-650-002).

 (2)
 Put the access platform adjacent to the refuel coupling 40QM.

 (3)
 Make sure that the chocks do not touch the tires. The weight of the fuel can lower the aircraft and catch the chocks.

 (4) Put the safety barriers in position.
 **ON A/C 051-051,

 Subtask 12-11-28-941-052-A
 A. Safety Precautions
 (1) You must obey the refuel/defuel safety precautions (Ref. TASK 12-11-28-650-001) (Ref. TASK 12-11-28-650-002).
 CAUTION : DO NOT REFUEL OR DEFUEL THROUGH THE TWO REFUEL/DEFUEL
_______ COUPLINGS AT THE SAME TIME. THIS IS TO PREVENT PRESSURE DIFFERENCE PROBLEMS.
 (2)
 Put the access platform adjacent to the applicable refuel coupling 100QM(40QM).

 (3)
 Make sure that the chocks do not touch the tires. The weight of the fuel can lower the aircraft and catch the chocks.

 (4)
 Put the safety barriers in position.

 **ON A/C ALL
 Subtask 12-11-28-281-052
 B. Drain the Water from the Fuel
 (1) Make sure that a fuel sampling for water contamination check is done to the fuel in the fuel tanker/pump unit (Ref. TASK 12-32-28-281-001).

R **ON A/C 001-049, 052-099, 101-149, 151-199, 201-299, 301-399, 401-499,
 Subtask 12-11-28-860-053
 C. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE FUEL SUPPLY HOSE IS CORRECTLY CONNECTED TO
_______ THE COUPLING BEFORE YOU REFUEL/DEFUEL THE AIRCRAFT. DO NOT CONNECT THE FUEL SUPPLY HOSE IF THERE ARE SIGNS OF DAMAGE TO THE AIRCRAFT COUPLING LUGS OR SLOTS.
 (1)
 Remove the refuel coupling cap 41QM.

 (2)
 Make sure that the aircraft and the fuel tanker/pump unit are grounded correctly (Ref. TASK 12-34-24-869-001) and electrically bonded together correctly.

 NOTE : Bonding is essential, grounding is recommended.
____
 (3)
 Make sure that the coupling of the fuel-supply hose is clean, then connect it to the aircraft refuel coupling.

 (4)
 Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).

 (5)
 Do the EIS (ECAM only) start procedure (Ref. TASK 31-60-00-860-001).

 (6)
 On the panel 11VU, push (in) the FUEL pushbutton switch.