A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Close the fan cowl doors: (Ref. TASK 71-13-00-410-040) FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR

 (3)
 Remove the warning notice(s).

 ENGINE STARTING - SERVICING
___________________________
 TASK 12-13-80-610-001
 Drain and Replenish Oil System
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 801110-C3
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific container 2l (0.5 USgal)
 No specific warning notice R No specific Torque Wrench : range 5.00 to 35.00 lbf.in R (0.05 to 0.40 m.daN)
 No specific Torque Wrench : range 36.00 to 220.00 lbf.in
 (0.40 to 2.60 m.daN)
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. CP2442 * engine oil (Ref. 70-30-00) Material No. CP8001 * lockwire 0.032 in. (0.8 mm) dia. (Ref. 70-30-00) Material No. CP8002 * lockwire 0.032 in. (0.8 mm) dia. (Ref. 70-30-00)

 C. Referenced Information

 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors
 71-13-00-410-040 Closing of the Fan Cowl Doors
 80-11-10-000-002 Removal of the Pneumatic Starter
 80-11-10-210-001 Check Chip Detector
 80-11-10-400-002 Installation of the Pneumatic Starter

R **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, R 401-499,
 12-13-80-991-300-A Fig. 301
 **ON A/C 051-061, 102-105, 201-203,
 12-13-80-991-300 Fig. 301A
 **ON A/C ALL
 3. Job Set-up
__________
 Subtask 12-13-80-941-052

 A. Safety Precautions
 (1)
 On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2)
 Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 (3)
 On the overhead maintenance panel 50VU:

 (a)
 Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b)
 Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 12-13-80-010-052
 B. Open the fan cowl doors: (Ref. TASK 71-13-00-010-040) FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR
 4. Procedure_________ 
R R  **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, 401-499,
 (Ref. Fig. 301/TASK 12-13-80-991-300-A)
 **ON A/C 051-061, 102-105, 201-203,
 (Ref. Fig. 301A/TASK 12-13-80-991-300) 
R R  **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, 401-499,
 Subtask 12-13-80-680-051-A
 A. Drain the starter
 (1) Remove the filler plug (10). Discard the O-ring (20).
 (2) Remove the knurled magnetic plug (50) as follow:
 (a) Push and turn counter-clockwise to release the plug (50).
 (3) Put a container below the starter. Cut and remove the lockwire. Remove the drain plug (70), and let the oil drain in the container 2l (0.5 USgal) . Discard the O-ring (80).
 (4) Measure the quantity of the drained oil:
 (a) If the oil quantity is more than 0.5 l (0.1320 USgal), the starter is serviceable.
 (b) If the quantity is less than 0.5 l (0.1320 USgal), replace the stater (Ref. TASK 80-11-10-000-002) (Ref. TASK 80-11-10-400-002).

 Pneumatic Starter Servicing Figure 301/TASK 12-13-80-991-300-A
R 1EFF : 001-049, 062-099, 101-101, 106-149, 1 12-13-80Page 304 1151-199, 204-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Pneumatic Starter Servicing
 Figure 301A/TASK 12-13-80-991-300

R 1EFF : 051-061, 102-105, 201-203, 1 12-13-80Page 305 1 1 May 01/05 1 1 1CES 1

 (5) Carefully examine the oil removed from the starter and the magnetic plug (50) for metal particles (Ref. TASK 80-11-10-210-001). Then, remove and discard the two O-rings (60).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM SERVICING 1(88)