(4)
Fill the reservoir with air until 50 psi is shown on the reservoir pressure gages 1383GM, 2383GM and 3383GM.
(5)
Turn the nut clockwise to close the ground connector.
(6)
TORQUE the nut to 0.15 m.daN (13.27 lbf.in). NOTE : Obey the limits (Ref. TASK 29-10-00-200-002), if there is a
____ decrease of the air pressure in the reservoirs.
**ON A/C 001-049, 051-061, 101-105, 201-203,
Subtask 29-14-00-870-050
B. Do the Bleeding Procedure of the Ram-Air Turbine System after maintenance of the Blue hydraulic system (Ref. TASK 29-00-00-870-010).
**ON A/C ALL
5. Close-up
________ Subtask 29-14-00-860-055
A. Put the system back to the serviceable condition.
(1) Remove the pressurizing tool.
(2)
Install the cap on the ground connector. Subtask 29-14-00-410-051
B.
Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the access door 195BB, 196BB and 197FB.
(3)
Close the applicable access panels (doors): For the ground service panel of the Green hydraulic system
-197CB For the ground service panel of the Blue hydraulic system
-197EB For the ground service panel of the Yellow hydraulic system
-198CB
(4)
Close the main door of the main gear (Ref. TASK 32-12-00-410-001). Subtask 29-14-00-865-051
C.
Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 2701GJ, 2702GJ, 3801GX, 3802GX, 3803GX.
1EFF : ALL 1 29-14-00Page 210 1 1 May 01/04R 1 1 1CES 1
HYDRAULIC RESERVOIR PRESSURIZING SYSTEM - SERVICING
___________________________________________________
TASK 29-14-00-680-001
Drain the Fluid Separator (1061GM)
1.
Reason for the Job
__________________
Refer to the MPD TASK: 291000-05
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific container
No specific plastic hose
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R 29-14-00-991-003-A Fig. 301
3. Job Set-up
__________
Subtask 29-14-00-010-060
A. Open the access panel 195BB.
4. Procedure
_________ R (Ref. Fig. 301/TASK 29-14-00-991-003-A) Subtask 29-14-00-680-050
A. Draining
(1)
Put the container into position below the air manifold.
(2)
Connect the plastic hose to the drain connection.
(3)
Push the drain valve and let any fluid drain into the container.
(4)
Release the drain valve and disconnect the plastic hose.
R R Draining of the Fluid Separator Figure 301/TASK 29-14-00-991-003-A
1EFF : 1 1 1CES ALL 1 111 29-14-00 Page 302 Feb 01/05
5. Close-up
________ Subtask 29-14-00-410-059
A. Close Access
(1)
Remove the container.
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
(3)
Close the access panel 195BB.
HYDRAULIC RESERVOIR PRESSURIZING SYSTEM - ADJUSTMENT/TEST
_________________________________________________________
TASK 29-14-00-720-001
Functional Test of the Pressurizing System of the Hydraulic Reservoirs
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific warning notices
98D29003501000 1 FILL UNIT - AIR
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓4(107)
