**ON A/C 001-049, 051-061, 101-103, 201-203,
Subtask 29-13-47-860-054
B. Aircraft Maintenance Configuration
(1)
Make sure that the Yellow Hydraulic system is depressurized (Ref. TASK 29-00-00-864-001).
(2)
Make sure that the applicable hydraulic reservoir has been depressurized (Ref. TASK 29-14-00-614-001).
(3)
Make sure that the isolation coupling of the PTU is disconnected (Ref. TASK 29-23-00-860-001).
(4)
Make sure that the access platform is in position.
(5) Make sure that the access panel 674AB is open. R **ON A/C 062-099, 104-149, 151-199, 204-299, 301-399, 401-499,
Subtask 29-13-47-860-054-A
B. Aircraft Maintenance Configuration
(1)
Make sure that the Yellow Hydraulic system is depressurized (Ref. TASK 29-00-00-864-001).
(2)
Make sure that the applicable hydraulic reservoir has been depressurized (Ref. TASK 29-14-00-614-001).
(3)
Make sure that the isolation coupling of the PTU is disconnected (Ref. TASK 29-23-00-860-001).
(4)
Make sure that the access platform is in position.
(5)
Make sure that the access panel 674AB is removed.
**ON A/C ALL
4. Procedure
_________
(Ref. Fig. 401/TASK 29-13-47-991-001)
Subtask 29-13-47-420-051
A. Preparation for Installation
(1)
Remove the blanking caps from the line ends.
(2)
Clean the component interfaces and the adjacent areas with a MISCELLANEOUS (Material No. 19-003) made moist with CLEANING AGENTS (Material No. 11-026)
(3)
Make sure that the parts retained from the removed component are clean and in the correct condition.
(4) Do an inspection of the component interface and/or the adjacent area. Subtask 29-13-47-420-050
B. Installation of the Compensated Slide R WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
_______ R - FLUSH IT AWAY WITH CLEAN WATER R - GET MEDICAL AID.
CAUTION : MAKE SURE THAT THE FLUID DOES NOT STAY ON THE AIRCRAFT
_______ STRUCTURE. IF THE FLUID GETS ON THE AIRCRAFT STRUCTURE, WASH IT OFF IMMEDIATELY WITH SOAP AND WATER.
(1)
Remove the blanking caps from the nut (5) and the fire shut-off valve (3).
(2)
Put the compensated slide (1) in position. NOTE : You can compress or extend the compensated slide to install
____
it.
(3)
Hold the nut (4) then connect and tighten the nut (5).
(4)
Hold the fire shut-off valve (3) then connect and tighten the nut (2).
Subtask 29-13-47-860-053
C. Aircraft Configuration
(1) Connect the Isolation Coupling of the Power Transfer Unit (PTU) (Ref. TASK 29-23-00-860-002).
Subtask 29-13-47-611-050
D. Fill and Pressurize the Hydraulic Systems WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES
_______ ARE CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓4(61)
