External Power
29-10-00-864-001 Depressurize the Green Hydraulic System
R 29-10-00-864-002 Depressurize the Yellow Hydraulic System 32-46-00-740-001 BITE Test of the BSCU 32-51-00-991-017 Fig. 514
3. Job Set-up
__________
Subtask 32-51-00-941-057
A. General
(1) Put a warning placard in the cockpit to tell persons not to operate R the landing gear or the N/WS.
(2)
On the panel 400VU, make sure that the L/G normal control lever is in the DOWN position.
(3)
On the nose gear leg, on the nose wheel steering deactivation electrical box, make sure that the towing lever is in the normal position (engaged position).
R 1EFF : 005-049, 055-099, 101-149, 151-199, 1 32-51-00Page A518 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
(4) Make sure that the N/WS handwheels and the rudder pedals are in the neutral position.
R **ON A/C 005-049, 055-099, 101-149, 151-199, 201-299, 301-399,
Subtask 32-51-00-860-072
B. Aircraft Maintenance Configuration
(1) Jack up the front of the aircraft (Ref. TASK 07-11-00-581-003).
NOTE : In the fully extended position of the shock absorber, the NLG____ is automatically centered (the nose wheel steering is in the zero position).
(2) Make sure that the Green hydraulic system is de-pressurized (Ref. TASK 29-10-00-864-001).
(3) Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
R **ON A/C 401-499,
R Subtask 32-51-00-860-072-A
R B. Aircraft Maintenance Configuration
R (1) Jack up the front of the aircraft (Ref. TASK 07-11-00-581-003).
R R R NOTE : In the fully extended position of the shock absorber, the NLG____ is automatically centered (the nose wheel steering is in the zero position).
R R (2) Make sure that the Yellow hydraulic system is de-pressurized (Ref. TASK 29-10-00-864-002).
R R (3) Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
R 1EFF : 005-049, 055-099, 101-149, 151-199, 1 32-51-00Page A519 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1R **ON A/C 005-049, 055-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 32-51-00-865-095
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY 4GG M36 121VU HYDRAULIC/BRAKING AND STEERING/SYS2/CTL 3GG M35
Subtask 32-51-00-865-096
D. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/BRAKING AND STEERING/SYS1/CTL 1GG M34 121VU HYDRAULIC/BRAKING AND STEERING/SYS1/IND AND/SPLY 2GG M33
4. Procedure
_________
(Ref. Fig. 514/TASK 32-51-00-991-017)
Subtask 32-51-00-220-057
A. Check of the play on the NLG cams
(1)
On the panel 402VU, put the A/SKID & N/W STRG switch in OFF position.
(2)
Disconnect the connector (4) from the RVDT 3GC (1).
(3)
Connect the SENSOR-VOLTAGE TEST (F26792000) or SENSOR - VOLTAGE TEST (F26792000-1) (3) between the connector (4) and the RVDT 3GC (1).
(4)
On the panel 402VU, put the A/SKID & N/W STRG switch in ON position.
(5)
Connect a AC voltmeter (minimum range: 0-20V, accuracy: 1 mV, frequency: 50-2000 Hz) to the SECONDARY VOLTAGE connections on the SENSOR-VOLTAGE TEST (F26792000) or SENSOR - VOLTAGE TEST.
R 1EFF : 005-049, 055-099, 101-149, 151-199, 1 32-51-00Page A520 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
Adjustment of the Sensor Box P/N E21336000, NLG cams as reference
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架9(17)
