曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (1) Drain the standby air data system (Ref. TASK 12-24-34-600-001). 
R  (2) Remove the slip on covers from the standby static probes and the 
R  standby pitot probe and connect the GENERATOR - GROUND PRESSURE MINI. 
R  100 MB (1.45 PSI) TO 1400 MB (20.3 PSI) to : 
R  - the L or R standby static probe with the ADAPTER COVER-STATIC PORT 
R  (98D34003500100). 
R  - the standby pitot probe with the ADAPTOR-CHARGING,PITOT PROBE. 
R  NOTE : The ADAPTOR-CHARGING,PITOT PROBE is on the drain hole. Thus it____ 
R  is not necessary to seal the drain hole of the pitot probe. 
R  (3) Seal the opposite standby static probe with the piece of plastic and 
R  with the STATIC PORT COVER (98D34003500103) from the ADAPTER COVER-
R  STATIC PORT.. 
R  (4) Precautions 
R  CAUTION : OBEY THESE PRECAUTIONS WHEN YOU DO THE TEST TO PREVENT_______ 
R  DAMAGE TO INSTRUMENTS: 
R  - PRESSURE SET MUST NOT BE MORE THAN 1050 hPa (31 in Hg) OR 
R  LESS THAN 115 hPa (3.39 in Hg) 
R  - CHANGES IN PRESSURE MUST NOT BE MORE THAN 6000 
R  FEET/MINUTE 
R  - DO NOT SUDDENLY OPEN LINES TO AMBIENT AIR WHILE THE 
R  PRESSURE GENERATOR IS CONNECTED. 
R  CAUTION : THE TOTAL PRESSURE IN THE PITOT SYSTEM MUST NEVER BE LESS_______ 
R  THAN THE STATIC PRESSURE. THE DIFFERENCE BETWEEN THE PITOT 
R  AND THE STATIC PRESSURE CIRCUITS MUST NEVER BE MORE THAN 
R  368 hPa (10.86 in Hg). 
R  (5) Start the ground pressure generator. 

R 1EFF : 201-212, 214-220, 1 34-21-00Page 511 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-212, 214-220,

 

 Subtask 34-21-00-865-056
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
105VU ELEC/CSM/G /EV AUTO/SPLY 7XE C01
 4. Procedure
_________
 Subtask 34-21-00-720-050

 A. Test of the Standby Airspeed Indicator
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
On the ground pressure generator :
-
set a static pressure of 314.8 hPa (29,000 ft)

-
set an impact pressure of 200.1 hPa (340 Kts).

 -
set a static pressure of 571.8 hPa (15,000 ft)

-
set an impact pressure of 153.5 hPa (300 Kts).

 -
set a static pressure of 843 hPa (5000 ft)

-
set an impact pressure of 53.5 hPa (180 Kts).

On the standby airspeed indicator:
-
the pointer shows 340 Kts (+ or - 5Kts).

-
the pointer shows 300 Kts (+ or - 4Kts).

-
the pointer shows 180 Kts (+ or - 3Kts).

 1EFF : 001-049, 051-099, 101-105, 151-199, 1 34-21-00Page 512 1201-212, 214-220, 1Aug 01/05 1 1 1CES 1 1EFF : 001-049, 051-099, 101-105, 151-199, 1 34-21-00Page 513 1201-212, 214-220, 1Aug 01/05 1 1 1CES 1

 5. Close-up________ 
R  **ON A/C 001-049, 051-099, 101-105, 151-199,
 Subtask 34-21-00-860-051
 A. Put the aircraft back to its initial configuration.
 (1) On the ground pressure generator, slowly decrease the pressure until you get atmospheric pressure.
 (2) Stop the ground pressure generator. 
R  (3) Disconnect the ground pressure generator. 
R R (4) Remove the adaptors from the standby static probes and the standby pitot probe. 
(5) Remove the cover from the opposite standby static probe. 
R  (6) Remove the piece of plastic from the opposite standby static probe. 
R R  (7) Remove the piece of plastic and colored adhesive tape from the drain holes of the standby pitot probe. 
R  (8) Install the slip on covers on the standby static probes and the standby pitot probe. 
R  **ON A/C 201-212, 214-220, 
R  Subtask 34-21-00-860-051-A 
R  A. Put the aircraft back to its initial configuration. 
R R  (1) On the ground pressure generator, slowly decrease the pressure until you get atmospheric pressure. 
R  (2) Stop the ground pressure generator. 
R  (3) Disconnect the ground pressure generator. 
R R  (4) Remove the adaptors from the standby static probes and the standby pitot probe.

 

R (5) Remove the cover from the opposite standby static probe.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航2(102)