- wiring of the YAW V1 COM and YAW V2 COM discretes (from the yaw damper servo-actuator,2 (3CC2) to the FAC 2 (1CC2))

 - servovalve of the SERVO ACTR-YAW DAMPER, 2 (3CC2)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 22-63-00-710-001 Operational Test of the Yaw Damper Function AMM 22-66-34-000-002 Removal of the FAC (1CC1,1CC2) AMM 22-66-34-400-002 Installation of the FAC (1CC1,1CC2) AMM 22-96-00-710-001 Operational Test of the AFS AMM 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the
 External Power AMM 27-26-51-000-001 Removal of the Yaw Damper Servo Actuator (3CC1) and
 (3CC2) AMM 27-26-51-000-002 Removal of the Servovalve AMM 27-26-51-000-003 Removal of the Solenoid Valve AMM 27-26-51-000-004 Removal of the Pressure Switch AMM 27-26-51-400-001 Installation of the Yaw Damper Servo Actuator (3CC1)
 and (3CC2) AMM 27-26-51-400-002 Installation of the Servovalve AMM 27-26-51-400-003 Installation of the Solenoid Valve AMM 27-26-51-400-004 Installation of the Pressure Switch AMM 29-10-00-863-003 Pressurize the Blue Hydraulic System with a Ground
 Power Supply
 AMM 29-23-00-863-001  Pressurize the Green Hydraulic System from the Yellow Hydraulic System through the PTU with the Electric Pump
 AMM 29-24-00-863-001 Pressurize the Yellow Hydraulic System with the
 Electric Pump
 ASM 22-68/04

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-63-00∞∞∞∞∞∞∞∞∞∞Page 205
 May 01/03 CES

 3. Fault Confirmation
__________________

 WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______
 YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.

 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES
_______ ARE CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
 A. Job Set-Up
 (1) Aircraft Maintenance Configuration
 (a) Energize the aircraft electrical circuits (Ref. AMM TASK 24-41-00-861-002).

 (b) Pressurize the aircraft hydraulic systems (Ref. AMM TASK 29-23-00-863-001), (Ref. AMM TASK 29-24-00-863-001) and (Ref. AMM TASK 29-10-00-863-003).

 B. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU AUTO FLT/FAC2/28VDC 5CC2 M19 121VU AUTO FLT/FAC2/26VAC 14CC2 M18
 C. Test
 (1) Open the circuit breaker 5CC2.

 (2) After a minimum of 10 seconds, close the circuit breaker 5CC2.

 (3) After 2 minutes, do the operational test of the AFS (Ref. AMM TASK 22-96-00-710-001) and read the result for the FAC 2.

 4. Fault Isolation
_______________
R
 A. If the test gives the maintenance message AFS: FAC2/YD ACTR2 3CC2: R R - open the circuit breakers 5CC2 and 14CC2, R - remove the FAC-2 (1CC2) (Ref. AMM TASK 22-66-34-000-002) and disconnect R the plug at the YAW DAMPER Servo-Actuator 2, R - do a check of the wiring between respectively:
R . The pins AF/4 and AF/6 of the FAC2 and the pins A/E and A/D of the
R YAW DAMPER Servo-Actuator,2,

R . The pins AC/4 and AC/6 of the FAC2 and the pins B/A and B/B of the
R YAW DAMPER Servo-Actuator,2.
R (Ref. ASM 22-68/04)

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞22-63-00∞∞∞∞∞∞∞∞∞∞Page 206
 May 01/03 CES

R (1) If the wiring is not correct:
R - repair it.

R (2) If the wiring is correct:
R - connect the above mentioned plug,
R - do a check of the impedance between respectively:

R . the pin AC/4 and the pin AC/6,

R . then the pin AF/4 and the pin AF/6 of the FAC-2 rack connector.

R NOTE : The impedance must be more than 40 Ohms.
____
R (a) If the impedance is correct:
R - replace the FAC-2 (1CC2) (Ref. AMM TASK 22-66-34-400-002).

R (b) If the impedance is not correct:
R - replace the solenoid valve 1 or 2 of the SERVO ACTR-YAW DAMPER,
R 2 (3CC2) (Ref. AMM TASK 27-26-51-000-003) and (Ref. AMM TASK
R 27-26-51-400-003),
R - install the above removed FAC-2 (1CC2) (Ref. AMM TASK 22-66-34-
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 AUTO FLIGHT 自動飛行1(107)