曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 NOTE: Before you replace a defective component, do the
____ BITE on the system (if it is applicable) and on the FMS interface subsystems with the defective component.
 2)  If it is necessary to do the Quick Test again, push the LSK adjacent to RERUN>.
 3)  To get the test result data, use the CDU keyboard to put the engineering code 100 into the scratchpad. Push the LSK 6R.
 4) To get out of the test result data, push the E key on the CDU keyboard. Push the LSK 6R. 5) Push the LSK adjacent to <CONTINUE to continue the quick test.
 (j)  If no failure occurs, the CDU display shows *QUICK TEST PASSED* and the Additional Tests Selection page.
 ~............................ | DFCS BITE TEST | | SUMMARY -A/-B 10. | | *QUICK TESTS PASSED* | | SELECT ADDITIONAL TESTS | | | | <AUTOPILOT | | | | <FLIGHT DIRECTOR | | | | <MACH TRIM SYSTEM | | | | <SPEED TRIM SYSTEM | | | | <ALTITUDE ALERT EXIT> | | | 2............................1
 NOTE: This permits the selection of the Interactive/Surface
____ tests for the five systems shown on the CDU display.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 22-11-01
 ú ú 01 Page 508 ú Jul 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 F.  Autopilot Test (Group 11)
 S 745-005
 (1)  
Push the LSK adjacent to <AUTOPILOT to start the autopilot
 interactive and surface tests.

 S 745-169

 (2)  
Do the autopilot interactive test:

 (a)  
Push the LSK adjacent to <CHANNEL A AND B.

 (b)  
Do the preparation steps as shown on the CDU display.

 (c)  
Push the LSK adjacent to the <CONTINUE to start the interactive test.

 (d)  
During this test, follow the instructions and push the LSK adjacent to <CONTINUE as shown on the CDU.

 

 NOTE: For the dual test when the CDU screen displays
____ "OPEN CB: ENG 1 N1", open circuit breaker C1182 EIS PRIMARY 1. When the CDU screen displays "OPEN CB: ENG 2 N1", open circuit breaker C1183 EIS PRIMARY 3.
 (e)  Make sure that the interactive test is completed with no failure.
 NOTE: If a failure occurs, the test will stop and the TEST
____ FAILED indication will show on the CDU display.
 (f)  If a failure occurs, do these steps:
 1)  From the CDU display, make a note of the test name, the channel, and the LRU that caused the failure.
 NOTE: The number XX.YY at the far right on the second line
____ is the Group number and Library Test number. The first two digits are the Group number and the last two digits are the Library number (Fig. 502).
 2)  If it is necessary to do the interactive test again, push the LSK adjacent to RERUN>.
 3)  To get the test result data, use the CDU keyboard to put the engineering code 100 into the scratchpad. Push the LSK 6R.
 4) To get out of the test result data, push the E key on the CDU keyboard. Push the LSK 6R. 5) Push the LSK adjacent to <CONTINUE to continue the interactive test.
 (g)  If no failure occurs, the surface test will start automatically.
 S 745-006
 (3)  Do the autopilot surface test:
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 22-11-01
 ú ú 01 Page 509 ú Mar 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
1. _________________________________AUTOPILOT TESTS - GROUP NUMBER 11
INTERACTIVE
ADI
MACH/AS
AFDS FMA
HSI HDG/CRS
MCP PUSHBUTTON
MCP C/O SW
MCP BNK LMT
MCP SPD KNB
MCP ALT KNB
MCP V/S KNB
MCP DISPLAY
INTERLOCK
ILS DEV WARN
ALT ALERT
DISENGAGE

SURFACE
ELEVATOR
AILERON
STAB TRIM
MACH TRIM
FLAPS
DUAL TEST

2. _______________________________________FLIGHT DIRECTOR TESTS - GROUP NUMBER 12
INTERACTIVE
ADI
LNAV
AFDS FMA
MCP PUSHBUTTON
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 1(118)