28-41-21
 ALL  ú ú 01 Page 506 ú Nov 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C98337
A 737-300/400/500MAINTENANCE MANUAL
COMPONENT  PIN NO.  EMPTY CAPACITANCE pf 
____________________NO. 1 OR 2 FUEL TANK 
COMP UNITF2  11S AND C  39.0 |1.2 
TANK UNITF4  2S AND 2  72.5 |1.2 
TANK UNITF6  4S AND 4  41.8 |1.2 
TANK UNITF8  6S AND 6  66.2 |1.2 
TANK UNITF21  6S AND 6  66.2 |1.2 
TANK UNITF9  7S AND 7  29.7 |1.2 
TANK UNITF18  12S AND 12  31.1 |1.2 
TANK UNITF12  10S AND 10  26.0 |1.2 
TANK UNITF11  9S AND 9  34.8 |1.2 
TANK UNITF10  8S AND 8  30.0 |1.2 
TANK UNITF7  5S AND 5  23.0 |1.2 
TANK UNITF5  3S AND 3  64.4 |1.2 
TANK UNITF3  1S AND 1  71.2 |1.2 
AIRPLANES WITH A CENTER TANK 
BUSSING PLUG ON THE REAR SPAR; 
CENTER TANK___________ 
COMP UNITF14  11S AND C  39.0 |1.2 
TANK UNITF17  8S AND 8  85.6 |1.2 
TANK UNITF16  9S AND 9  78.6 |1.2 
AIRPLANES WITHOUT A CENTER TANK 
BUSSING PLUG ON THE REAR SPAR; 
1 
CENTER TANK___________ 
COMP UNITF14  1 AND 3  39.0 |1.2 
TANK UNITF17  1 AND 2  164.2 |1.2 
TANK UNITF16  1 AND 2  164.2 |1.2 

TABLE B

____NOTE:  THE TANK UNITS NO. F8 AND F21 ARE WIRED IN PARALLEL. 
PIN NUMBERS CORRESPOND TO NUMBERS ON THE TEST HARNESS AND PIN NUMBERS ON THE AIRPLANE 
CONNECTOR RECEPTACLE. 

1 THE TANK UNITS NO. F17 AND F16 ARE WIRED IN PARALLEL. THE TANK UNITS AND THE COMPENSATOR HAVE A COMMON HI-Z WIRE.
Tank and Compensator Unit Capacitance and Resistance Values
Figure 502 (Sheet 3)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-41-21
 ALL  ú ú 01 Page 507 ú Nov 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C98338
A
737-300/400/500MAINTENANCE MANUAL
 S 715-010
 (11) Measure the capacitance of each tank unit and compensator unit. NOTE: The capacitance must be as shown in Fig. 502, Table B.
____
 S 085-012
 (12)
 Remove the bolts from the adapter plug. S 085-019

 (13)
 Remove the adapter plug. S 485-024

 (14)
 Connect the bussing plug to the receptacle (AMM 28-41-41/401).

 S 715-014

 (15)
 Do the procedure again for the other fuel tanks.

 S 865-015

 (16)
 Remove the DO-NOT-CLOSE tags and close these circuit breakers:

 CAUTION:_______ BE CAREFUL WITH THE CONNECTOR PINS AND SOCKETS.  THE CONNECTOR
 RECEPTACLE IS PART OF THE TANK WIRE HARNESS.  IF THERE IS
 DAMAGE TO THE RECEPTACLE, IT IS NECESSARY TO REMOVE THE
 ASSEMBLY.

 (a)  P6 Main Power Distribution Panel 1) EP GND FUELING 2) QTY
 S 095-021
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
_______ LE FLAP SAFETY LOCKS. THE LE FLAPS CAN MOVE QUICKLY IF YOU DO NOT REMOVE THE SAFETY LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (17) Remove the leading edge flap locks if you installed them before (AMM 27-81-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-41-21
 ALL  ú ú 07 Page 508 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-042 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF THE LE AND TE
_______ FLAPS AND FLAP DRIVE MECHANISMS BEFORE YOU MOVE THE FLAPS. THE FLAPS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (18) Retract the leading edge flaps if they are extended (AMM 27-81-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燃油 FUEL 3(116)