S 864-042

 (4)  
Remove the external electrical power from the airplane
 (AMM 24-22-00/201).

 S 864-043
 WARNING: CAREFULLY DO ALL OF THE SAFETY PROCEDURES TO PREPARE TO GO
_______ INTO THE FUEL TANK. AN EXPLOSION, BAD INJURIES TO PERSONS, AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (5)  
Do this task: "Fuel Tank Purging and Entry" for the No. 1 tank and the center tank (AMM 28-10-00/201).

 (6)  
Open the access door for the center tank (AMM 28-11-31/401).

 S 034-047

 (7)  
Remove the bolt and the washer that attaches the support clamp to the APU fuel line (4 locations) (View A, Fig. 401).

 S 494-048

 (8)  
Put a container below the connection of the APU fuel line and the bulkhead union (View B, Fig. 401).

 S 014-046
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-22-81
 ALL  ú ú 02 Page 411 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 034-054
 (9)  Disconnect the coupling nut for the APU fuel line at the bulkhead union (View B, Fig. 401).
 S 024-049
 CAUTION: BE CAREFUL WHEN YOU MOVE THE APU FUEL LINE OUT OF THE CENTER
_______ SECTION. YOU CAN CAUSE DAMAGE TO THE FUEL LINE AND THE AIRPLANE STRUCTURE.
 (10) Remove the part of the APU fuel line in the center section.
 (a)  
Disconnect the coupling nut for the fuel line at the interconnect fitting (View C, Fig. 401).

 (b)  
Move the APU fuel line out of the center section.

 TASK 28-22-81-404-050
 5. APU Fuel Line Installation (Center Section)
__________________________
 A. Equipment
 (1)  Source - Air pressure, 40 psi maximum
 B. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 28-11-11/401, Wing Fuel Tank Access Panels

 (3)  
AMM 28-11-31/401, Center Tank Access Panel.

 C. Access
 (1)  
Location Zones
 221 Center Section Tank
 305 Left Fuel Tank

 (2)  
Access Panel
 7202 Fuel Tank Access Door

 D. Procedure
 S 564-051
 (1)  
Put the APU fuel line through the access panel opening for the center tank and the openings in the beams along the spans in the center tank.

 S 434-052

 (2)  
Connect the coupling nuts for the APU fuel line.

 (a)  
Tighten the coupling nuts with your fingers only.

 (b)  
Put the line in the correct position.

 (c)  
Install the support clamps (4 locations).

 (d)  
Tighten the coupling nuts.

 S 794-053
 (3)  Pressurize the APU fuel line and do a check for leaks.
 (a)  
Go into the No. 1 tank.

 (b)  
Make sure the fuel shutoff valve is closed.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-22-81
 ALL  ú ú 02 Page 412 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (c)  
Remove the relief valve from the T-fitting at the 70.85 rib web.

 (d)  
Put a plug in the port at the T-fitting.

 (e)  
Go into the APU compartment.

 (f)  
Disconnect the fuel line at the APU fuel filter.

 (g)  
Attach the air pressure source and the pressure gage to the fitting.

 (h)  
Pressurize the APU fuel line to a maximum pressure of 40 psi.

 (i)  
Keep the pressure on the APU fuel line for a minimum of 5 minutes.

 (j)  
Look for signs of external leakage on all of the connections and the fittings on the APU fuel line.

 (k)  
There must be no leakage.

 (l)  
Release the pressure.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燃油 FUEL 3(7)