(a) The SG must contain this piece of software: 1) Operational Program Software (OPS)
(2)
A Portable Data Loader (PDL) is necessary for this procedure.
(3)
A Tray Adapter is necessary for this procedure.
(4)
The airplane must be on the ground with the engines off before you can install the software.
B. References
(1)
AMM 20-10-07/201, E/E Rack-Mounted Components
(2)
AMM 34-22-41/401, EFIS SYMBOL GENERATOR - REMOVAL/INSTALLATION
C. Access
(1)
Location Zone
205 Electronic Compartment
(2)
Access Panel
1201 Electronic Equipment Access Door
D. Equipment
(1) C34006-58 Adapter, Tray - EFIS SYMBOL GENERATOR software loading (alternative)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH THE COLLINS ú
34-22-41
SYMBOL GENERATOR P/N 622-9436-101 ú
(BOEING P/N S242T404-421) AND ON. ú 01 Page 201 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(2)
C34006-54 Adapter, Tray - EFIS SYMBOL GENERATOR software loading (alternative)
(3)
C34006-2 Adapter, Tray - EFIS SYMBOL GENERATOR software loading (alternative)
(4)
964-0400-025 Loader - Data, Portable, ARINC 615, 3.5 Inch Diskette (alternative), Allied Signal Commercial Avionics Systems, 2100 N.W. 62nd Street, P.O. Box 9414, Fort Lauderdale, FL 33309
(5)
465130-01-01 Loader - Data Portable, ARINC 615, 3.5 Inch Diskette (alternative) Litton Systems Inc., 6101 Condor Drive, Moorpark, CA 93021-2602
(6)
964-0400-024 Loader - Data, Portable, ARINC 615, 3.5 Inch Diskette (alternative), Allied Signal Commercial Avionics Systems, 2100 N.W. 62nd Street, P.O. Box 9414, Fort Lauderdale, FL 33309
(7)
30100 Loader - Data Portable, ARINC 615, 3.5 Inch Diskette (alternative) Demo Systems Inc., 5450 Tech Circle, Moorpark, CA 93021
E. Procedure
S 862-036
(1)
Do this task: Supply Electrical Power (AMM 24-22-00/201).
S 472-042
(2)
Use a PDL and Tray Adapter to install software in the SG.
NOTE: You must know the correct software part number for the
____ SG. For the SG to be an approved installation, you must install the software with the correct part number. You can do a check of the SG software part number with the EFIS Symbol Generator Test (AMM 34-22-41/401).
S 842-038
(3) Do these steps to prepare for the software installation:
(a)
Set the EFI Transfer Switch on the pilots' overhead panel to NORMAL.
(b)
Open these circuit breakers and attach DO-NOT-CLOSE tags: 1) On the circuit breaker panel, P18-2 a) C01110, EFIS SYMBOL GENERATOR - LEFT
2) On the circuit breaker panel, P6-1 a) C01114, EFIS SYMBOL GENERATOR - RIGHT
(c)
Remove the EFIS SYMBOL GENERATOR - LEFT. Do this task: EFIS Symbol Generator Removal (AMM 34-22-41/401).
(d)
Install the Tray Adapter in the EFIS SYMBOL GENERATOR - LEFT tray. Make sure that the Tray Adapter is fully seated in the tray.
(e)
Install the EFIS SYMBOL GENERATOR - LEFT in the Tray Adapter. Make sure that the SG is fully seated in the Tray Adapter.
(f)
Set the power switch on the PDL to OFF.
(g)
Connect the interface cable from the PDL to the Tray Adapter.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH THE COLLINS ú
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 1(143)
