E. Procedure
S 864-008
(1) Make sure these circuit breakers are open with the DO-NOT-CLOSE tags attached:
(a)
P18 Load Control Center
1) A8, COMPUTER-1 AC
2) A9, COMPUTER-1 26V AC
3) C5, TEMP PROBE
(b)
P6 Load Control Center
1) B6, COMPUTER-2 26V AC
2) B7, COMPUTER-2 AC
S 104-009
(2)
Clean and prepare the surface of the airplane around the installation hole.
S 424-010
(3)
Install the total air temperature probe:
(a)
Install the new gasket.
(b)
Remove the dust caps from the electrical connections.
(c)
Connect the electrical connector to the TAT probe.
(d)
Put the electrical connector into the airplane.
(e)
Align the TAT probe with the installation hole.
(f)
Install the screws that hold the TAT probe to the airplane.
(g)
Make sure the TAT probe aligns smoothly with the airplane skin.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 02 Page 403 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
(4) S 864-014Remove the DO-NOT-CLOSE tags and close these circuit breakers: (a) P18 Load Control Center 1) A8, COMPUTER-1 AC 2) A9, COMPUTER-1 26V AC 3) C5, TEMP PROBE
(b) P6 Load Control Center 1) B6, COMPUTER-2 26V AC 2) B7, COMPUTER-2 AC
(5) S 224-015Measure the resistance between the TAT probe body and the airplane skin. (a) Make sure the resistance is less than 0.010 ohms.
(6) S 704-016Do a test of the heater circuit of the TAT probe (Ref 30-31-00/501).
(7) S 394-020Seal around the TAT probe and the airplane skin with the sealant.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 01 Page 404 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
TOTAL AIR TEMPERATURE PROBE - ADJUSTMENT/TEST
_____________________________________________
1. General_______
A. This procedure contains two tasks. The first task is a resistance test of the Total Air Temperature (TAT) probe. The second task is a heater test of the TAT probe.
TASK 34-12-31-715-001
2. Total Air Temperature Probe Resistance Test___________________________________________
A. Equipment
(1) Ohmmeter - low excitation voltage type
B. Reference
(1) AMM 34-12-31/701, Total Air Temperature Probe
C. Access
(1) Location Zones
101/102 Flight Compartment
D. Prepare for Test
S 865-003
(1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a)
P18 Load Control Center
1) A8, COMPUTER-1 AC
2) A9, COMPUTER-1 (26V AC)
3) C5, TEMP PROBE
(b)
P6 Load Control Center
1) B6, COMPUTER-2 26V AC
2) B7, COMPUTER-2 AC
E. Total Air Temperature Probe Resistance Test
S 215-004
(1)
Examine the air inlet scoop and exhaust ports for unwanted material.
S 105-005
(2)
Clean the TAT probe if there is unwanted material
(AMM 34-12-31/701).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 03 Page 501 ú Nov 12/00 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 1(96)
