CAUTION: DO NOT DISCONNECT THE PNEUMATIC TEST SET UNLESS THE
_______ PITOT-STATIC SYSTEM IS AT AMBIENT PRESSURE. YOU CAN CAUSE DAMAGE TO THE EQUIPMENT.
 (2)  
Disconnect the pneumatic test set from the pitot-static probe adapters.

 S 865-043

 (3)  
Remove the probe adapters from all of the pitot-static probes.

 (a)  Remove the probe adapters from the probes.
 NOTE: Dry off the pitot-static probes with a soft rag when you
____ use ethylene glycol.
 CAUTION: MAKE SURE THAT YOU REMOVE ALL OF THE PIECES OF TAPE FROM
_______ EACH PITOT-STATIC PROBE. THE SYSTEM WILL NOT OPERATE CORRECTLY UNLESS THE TAPE IS REMOVED.
 (b)  Remove the vinyl adhesive tape from all of the probe pitot chamber drain holes.
 WARNING: WHEN THE STATIC PORTS ARE COVERED, MAKE SURE THAT
_______ CONDITION IS VISIBLE FROM THE GROUND. FAILURE TO OBSERVE AND REMOVE COVERINGS FROM THE STATICPORTS BEFORE FLIGHT MAY CAUSE LARGE ERRORS IN AIRSPEED SENSING AND ALTITUDE SENSING SIGNALS, WHICH MAY LEAD TO LOSS OF SAFE FLIGHT.
 (c)  Remove the vinyl adhesive tape from the upper left and lower left probe static ports (S1 and S2).
 S 865-044
 (4)  
Examine the pitot-static probes for unwanted materials and rough locations on the inner and outer surfaces (Ref 34-11-11/601).

 S 865-045

 (5)  
Make sure that the pitot-static probes do not show damage to the pitot tip or the static ports (Ref 34-11-11/601).

 (6)  
Remove all of the pitot-static pneumatic test hoses and equipment.

 S 865-046
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-11-01
 ú ú 02 Page 509 ú Mar 15/98

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-047
 (7)  
Close the STALL WARNING NO. 1 and NO. 2 circuit breakers on load control panels P6 and P18.

 S 865-048

 (8)  
Close the FLAP LOAD RELIEF circuit breaker on the load control panel P6.

 S 865-049

 (9)  
Remove the cap and connect the cabin altitude differential pressure indicator to its static pressure source.

 S 845-050

 (10)
 Install the drain fitting caps that were removed from all of the pitot-static system drains.

 S 865-333

 (11)
 Remove electrical power if it is not necessary (AMM 24-22-00/201).

 TASK 34-11-01-795-052
 3.  The Captain's Pitot System Leak Test____________________________________
 A. Standard Tools and Equipment
 (1)  
Air data test set, Castleberry AT700-2, Castleberry Instr & Avionics, Austin, TX; or equivalent

 (2)  
Pitot-static probe adapter kit, P/N AD-953-7, Nav-Aids Ltd., Montreal, Canada; or equivalent

 (3)  
Flow restrictors, control valves, cutoff valves, vinyl adhesive tape, and port seals as required

 B. References
 (1)  
24-22-00/201, Manual Control

 (2)  
34-11-11/601, Pitot-Static Probe

 C. Prepare for the Test
 S 845-053
 (1)  Supply electrical power (AMM 24-22-00/201).
 S 865-334
 WARNING:_______YOU MUST OPEN THE FLAP LOAD RELIEF CIRCUIT BREAKER. YOU CAN CAUSE INJURY TO PERSONS.
 (2)  Open the FLAP LOAD RELIEF circuit breaker on the load control panel P6.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-11-01

 ú ú 02 Page 510 ú Mar 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-335 CAUTION: YOU MUST OPEN THE DIGITAL STALL WARNING COMPUTER (DSWC) CIRCUIT
_______ BREAKERS. YOU CAN CAUSE THE DSWC TO FAIL THE SELF-TEST UNTIL IT IS SET AGAIN.
 (3)  Open the STALL WARNING NO. 1 and NO. 2 circuit breakers on load control panels P6 and P18.
 S 865-336
 WARNING:_______MAKE SURE THAT THE PROBE HEAT IS NOT ON. YOU CAN CAUSE INJURY TO PERSONS.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 1(43)