EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-12-31
 ALL  ú ú 01 Page 411 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / GTCP85-129 SERIES /737-300/400/500/ ENGINES/MAINTENANCE MANUAL ////////////////////////
(i)  AIRPLANES WITH THE ETC; Connect the receptacle for the ETC, D10140, to the fitting on the upper shroud.
 S 434-035
 (11) Connect the airplane bonding jumper to the upper shroud with the bolt, four washers, and nut (Ref Standard Wiring Practices Manual).
 (a)  Make sure the bonding resistance is a maximum of 0.0025 ohms (Ref Standard Wiring Practices Manual).
 S 434-052
 (12) Connect the pressure line:
 (a)  Remove the plug from the pneumatic actuator for the shutoff valve for the cooling air.
 NOTE: To get to the pneumatic actuator and the pressure line,
____ go through the access door for the stabilizer trim.
 (b)  
Remove the cap from the pressure line.

 (c)  
Connect the pressure line to the pneumatic actuator for the shutoff valve for the cooling air.

 S 414-037
 (13)
 Close the access door, 3701, for the stabilizer trim.

 S 434-038

 (14)
 Install the APU power plant (AMM 49-11-00/401).

 S 864-039

 (15)
 Remove the DO-NOT-CLOSE tags and close these circuit breaker:

 (a)  P6-2 Load Control Center Assembly
 1) STABILIZER TRIM, CONT

 (16)
 Put the horizontal stabilizer trim in the neutral position.

 S 864-040
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-12-31
 ALL  ú ú 02 Page 412 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
APU SHROUD LATCH - ADJUSTMENT/TEST
__________________________________
 1.  General
_______
 A.  This procedure gives the task to adjust the latch bolts that attach the lower shroud to the upper shroud. The latch bolts must have the correct tension to latch the lower shroud to the upper shroud. The latch bolts must have a latch nut and a jamnut installed.
 B.  Do the adjustment task with the lower shroud installed and all the latches closed.
 C.  You can get access to the APU shroud latches through the APU cowl door.
 TASK 49-12-41-805-001
 2.  APU Shroud Latch Adjustment (Fig. 501)
___________________________
 A.  Access
 (1)  
Location Zones
 101 Control Cabin, LH
 205 Electronic Compartment
 703 APU Compartment

 (2)  
Access Panels
 1201 Electronic Equipment Access Door
 3804 APU Cowl Door

 B.  Procedure
 S 865-002
 (1)  Set the switch and the circuit breaker:
 (a)  
Set the APU master switch on the P5 forward overhead panel to the OFF position and attach a DO-NOT-OPERATE tag.

 (b)  
Open this circuit breaker and attach a DO-NOT-CLOSE tag: 1) E3-3 Electrical Shelf, APU Control Unit

 S 015-003
 (2)  Open the APU cowl door:
 (a)  
Open the latches for the APU cowl door.

 (b)  
Open the APU cowl door.

 (c)  
Connect the door support rods.

 S 825-004
 (3)  Adjust the APU shroud latches:
 (a)  Open one shroud latch assembly.
 1)  While you open the latch assembly, measure the quantity of force that is necessary to open the latch.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-12-41
 ALL  ú ú 01 Page 501 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / GTCP85-129 SERIES /737-300/400/500/ ENGINES /MAINTENANCE MANUAL ////////////////////////
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 AIRBORNE AUXILIARY POWER 1(121)