(2)
AMM 24-22-00/201, Manual Control (Apply Power)
B. Access
(1) Location Zone 118 Electrical and Electronics Compartment, Right
C. EIU Shop Faults List (Optional)
S 864-121
(1)
Supply electrical power (AMM 24-22-00/201).
S 864-122
(2)
Show the EIU shop faults, for the EIU that you will remove, on the CDU:
NOTE: The <31 INDICATING/WARNING shop LRU menu and the shop fault
____ data pages may not be shown when selected. Also the previous or the next page when selected by the PREV or NEXT PAGE keys on the CDU may not be shown. If this occurs select the <RETURN prompt key to go back one page, and then continue to make selections in a normal manner to get to the menu that you need.
(a)
Push the <OTHER FUNCTIONS LSK (line select key) on the CMC menu.
(b)
Push the <SHOP FAULTS LSK on the other functions menu.
(c)
Push the <31 INDICATING/WARNING LSK on the shop faults menu.
(d)
Push the <IDS-EIU-L, <IDS-EIU-C, or <IDS-EIU-R LSK to see the shop faults for the left, center, or right EIU.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-61-01
ALL ú ú 01 Page 401 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
NOTE: The CDU may show a "NO FAULT" or a "NO FAULT L" on the
____ shop faults data for an EIU again and again. If this occurs no maintenance action is required and the fault may be ignored.
S 974-123
(3)
Make a list of the shop faults.
S 864-124
(4)
Remove electrical power, if it is not necessary (AMM 24-22-00/201).
D. Remove the EIU
S 864-125
(1) Open the circuit breaker for the EIU you will replace and attach a DO-NOT-CLOSE tag:
(a) P7, Overhead Circuit Breaker Panel
1) 7F9, EIU L
2) 7F10, EIU C
3) 7F15, EIU R
S 024-154
CAUTION: DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS ON THE
_______ EFIS/EICAS INTERFACE UNIT (EIU). IF YOU TOUCH THESE CONDUCTORS, ELECTROSTATIC DISCHARGE FROM YOUR BODY CAN CAUSE DAMAGE TO THE EIU.
(2) Remove the EIU from the electronic equipment rack
(AMM 20-11-22/401).
TASK 31-61-01-424-165
3. EIU Installation
________________
A. References
(1) AMM 20-11-22/401, Rack-Mounted Electrical/Electronic Module
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-61-01
ALL ú ú 02 Page 402 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
(2)
AMM 24-22-00/201, Manual Control (Apply Power)
(3)
AMM 31-61-10/201, Integrated Display System Software Installation
(4)
AIPC 31-61-01, Fig. 1
B. Access
(1) Location Zones
118 Electrical and Electronics Compartment, Right
221 Control Cabin, LH
222 Control Cabin, RH
C. Install the EIU
S 864-129
(1) Make sure the circuit breaker for the EIU you will replace is open with a DO-NOT-CLOSE tag attached:
(a) P7, Overhead Circuit Breaker Panel
1) 7F9, EIU L
2) 7F10, EIU C
3) 7F15, EIU R
S 424-155
CAUTION: DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS ON THE
_______ EFIS/EICAS INTERFACE UNIT (EIU). IF YOU TOUCH THESE CONDUCTORS, ELECTROSTATIC DISCHARGE FROM YOUR BODY CAN CAUSE DAMAGE TO THE EIU.
(2) Install the EIU in the electronic equipment rack (AMM 20-11-22/401).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 指示/記錄系統 2(149)
