国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽

  • 熱門標簽

當前位置: 主頁 > 航空資料 > 飛行資料 >

時間:2011-04-22 09:48來源:藍天飛行翻譯 作者:航空
曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

At certain weights and CG positions, it may not be possible to satisfy . target demands at VLS. Consequently, when obstacle clearance is assured, accelerate to a speed at which the . target can be satisifed.
TWO ENGINES INOPERATIVE LANDING (A343/A346) General
Operational requirements following a second engine failure are detailed in Volume 2 Part 2. Continued flight may be complicated by driftdown, lateral navigation requirements to ensure terrain clearance, fuel jettison to achieve desired performance and other factors.
It is recommended that weather at the selected ERA should permit visual flight on approach from at least 500 ft AGL to the runway. The primary consideration for approach, landing and go-around is one of control. Go-arounds in particular require careful planning, briefing and execution to ensure controllability margins are not compromised.
The nature of the failure also needs to be considered, particularly which combination of engines and associated hydraulic systems have been lost.
Loss Of One Engine On Each Wing
For the loss of any two engines from opposite wings, VLS on the MCDU and PFD is limited to VMCL (A343: 125 kt), (A346: 132 kt). The loss of engines 1 and 4 does not have a major effect on control, however without the green hydraulic system a manual landing gear extension is required and there is no retraction capability. Consequently a go-around is not possible after L/G extension and the aircraft is committed to land . Landing must be assured prior to L/G extension.

A330/A340 8.20.13 Operating Techniques
FCTM REV 1 (6 JUN 05)
Loss Of Two Engines On The Same Wing
Control of the aircraft is more complicated following the loss of two engines on a single wing. The critical factor is speed, which must not reduce below VMCL-2 (157 kt) until landing is assured. VLS displayed on the PFD will never be lower than VMCL-2. Speed reduction below VMCL-2 is permissible once landing is assured. L/G retraction is available in the event of a go-around, but failure to maintain VMCL-2 with TOGA thrust applied and an insufficient bank angle, will result in loss of directional control.
Approach
A “Commit Altitude” is established for any two engine approach. The equivalent height should never be below 500 ft AGL. It serves two purposes; to establish a decision point on approach from which a “land or go-around” decision can be made, and because it is well above the Cat 1 minima (200 ft AGL), it provides a 300 ft buffer. In the event of a performance-limited go-around, this buffer can be used to descend and clean up whilst easily ensuring that speed will be well above VMCL-2 when the nose is raised to climb away.
The Commit Altitude should be inserted on the MCDU PERF APPR page as the MDA, but is not a “not below” altitude in the conventional sense.
Autothrust is disconnected once stabilised on final approach. At the Commit Altitude with the landing assured, speed may be reduced to normal VAPP. In the case of two engines inoperative on the same wing, VAPP will be below the VLS displayed on the PFD (VMCL-2), e.g based on the MCDU VLS in case of loss of two engines on the same wing. Speed reduction below VMCL-2 is acceptable at this stage, as VMCL-2 is based on the use of TOGA thrust on the remaining engines, and adequate margins remain at normal approach speeds and thrust settings.
Go-Around
If a landing is not assured by the Commit Altitude (or immediately prior to L/G extension with engines 1 and 4 inoperative), then a go-around should be initiated. If the approach has been flown accurately, the speed will be at VLS.
TOGA thrust should be selected. At certain weights and CG positions, it may not be possible to satisfy the a target demands at VLS. If two engines are inoperative on the same wing, this may require leading with the inboard thrust lever. TOGA should be achieved on the outboard engine as soon as directional control permits, but without undue delay. When obstacle clearance is assured, accelerate to a speed at which the a target.can.be.satisfied.
 
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址:A330/A340 機組訓練手冊 FCTM Flight Crew Training Manual(73)

国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽
欧洲精品久久| 日本一区二区三区在线播放| 色综合久久精品亚洲国产| 午夜免费日韩视频| 国产亚洲精品美女久久久m| 国产高清精品一区二区三区| 国产精品第一页在线| 欧美自拍大量在线观看| 97久久国产亚洲精品超碰热| 国产精品入口福利| 日韩一级免费看| 91久久久一线二线三线品牌| 国产精品久久成人免费观看| 日韩av一区二区三区在线观看| 国产免费成人av| 久久99国产精品一区| 亚洲欧美久久久久一区二区三区| 精品日韩美女| 久久精品人人做人人爽| 日韩亚洲一区在线播放| 久久综合中文色婷婷| 一本久道高清无码视频| 国内伊人久久久久久网站视频| 久久久久久久爱| 日本人妻伦在线中文字幕| 91精品国产91久久久久福利| 亚洲午夜精品一区二区| 国产精品主播视频| 色综合久久久久久中文网| 国产日韩欧美综合精品| 国产精品人成电影在线观看| 欧美久久综合性欧美| 久久久久综合一区二区三区| 日本一道本久久| 久久久爽爽爽美女图片| 亚洲v日韩v欧美v综合| av在线不卡一区| 亚洲精品成人久久久998| αv一区二区三区| 亚洲精品成人三区| 国产高清精品在线观看| 日韩精品一区二区三区四| 国产高清一区二区三区| 区一区二区三区中文字幕| 久久黄色片视频| 日日噜噜夜夜狠狠久久丁香五月| 久久这里只有精品18| 欧美一级片免费观看| 国产成人精品久久久| 秋霞成人午夜鲁丝一区二区三区| 国产成人精品在线视频| 国产在线观看精品一区二区三区| 久久99国产精品久久久久久久久| 国产精品后入内射日本在线观看| 日本韩国在线不卡| 欧美激情第三页| 丝袜美腿精品国产二区| 99精品视频在线看| 欧美午夜精品久久久久免费视| 国产精品日韩欧美一区二区| 男人添女人下部视频免费| 国产精品久久久久久超碰| 成人久久18免费网站图片| 婷婷亚洲婷婷综合色香五月 | 国产美女永久无遮挡| 国语自产精品视频在线看| 国产精品男女猛烈高潮激情| 久久精品国产理论片免费| 国产免费一区| 久久久久久久久网| 亚洲国产精品www| 国产精品无码专区在线观看 | 国产福利视频一区二区| 日本精品一区二区三区不卡无字幕| 久久久精品中文字幕| 国产情人节一区| 日本精品福利视频| 色综合久久88| 北条麻妃一区二区三区中文字幕| 国产精品一区二区久久精品| 日本欧美在线视频| 欧美久久久精品| 久久99久久99精品蜜柚传媒| 国产精品夜夜夜爽张柏芝| 欧美日韩国产综合在线| 一本大道熟女人妻中文字幕在线| 日韩在线免费视频| 粉嫩av免费一区二区三区| 日韩av电影在线免费播放| 国产精品美女久久| 久久露脸国产精品| 国产欧美一区二区三区久久| 日韩极品视频在线观看| 在线观看污视频| 国产精品丝袜视频| 国产精品6699| 国产精品亚洲二区在线观看| 欧美激情第一页在线观看| 色噜噜色狠狠狠狠狠综合色一| 欧美精品在线网站| 久久精品电影网站| 97久久伊人激情网| 精品一区国产| 日产精品久久久一区二区福利| 久久国产精品99国产精| 日韩在线观看高清| 久久人妻精品白浆国产| 国产美女被下药99| 国内少妇毛片视频| 青青青免费在线| 五月天在线免费视频| 欧美伦理91i| 国产精品高潮呻吟视频| 久久精品99国产精品酒店日本| 7777免费精品视频| 成人91免费视频| 国产日韩第一页| 免费观看国产精品视频| 日韩人妻无码精品久久久不卡| 一本色道久久综合亚洲二区三区| 不卡毛片在线看| 国产精品久久久久久久久电影网 | 欧美人与性动交a欧美精品| 久久国产一区| 久久青青草原| 久久久人成影片一区二区三区观看| 国产精品夜间视频香蕉| 国产三区精品| 国产情人节一区| 国产日韩欧美成人| 国产三区二区一区久久| 国产一区二区自拍| 欧美中文字幕在线视频| 日本精品一区二区三区在线| 日本在线观看一区| 色大师av一区二区三区| 日韩在线第一区| 日日鲁鲁鲁夜夜爽爽狠狠视频97| 亚洲精品久久区二区三区蜜桃臀 | 久久激情视频免费观看| 精品久久国产精品| 久久天天躁狠狠躁老女人| 久久精品国产久精国产一老狼 | 色大师av一区二区三区| 日本久久中文字幕| 日韩欧美亚洲日产国| 日韩精品一区二区三区丰满| 青青草国产免费| 欧美久久久久久久久久久久久久| 欧美高清视频一区| 国产视频99| 91精品国产自产在线观看永久| 性色av一区二区咪爱| 日本三级韩国三级久久| 欧美两根一起进3p做受视频| 国产中文字幕视频在线观看| 国产视频999| 国产伦视频一区二区三区| 91麻豆国产语对白在线观看| 国产精品99久久久久久人| 久久99精品久久久久久水蜜桃 | 日本高清+成人网在线观看| 欧美在线www| 国产在线精品二区| 91精品国产高清久久久久久久久| 久久久免费在线观看| 日韩在线免费av| 不卡中文字幕av| 亚洲国产一区二区三区在线| 精品国产一区二区三区在线| 一区二区免费电影| 日本www高清视频| 国内精品视频在线| www.日日操| 久久久久久久中文| 国产精品青青草| 一区二区三区一级片| 日本欧美精品在线| 激情小说综合区| 99国产精品白浆在线观看免费| 久久青青草原| 91精品国产777在线观看| 日韩专区中文字幕| 国产精品视频免费一区二区三区| 久久夜精品va视频免费观看| 综合一区中文字幕| 日本一区二区免费高清视频| 日韩精品一区二区三区四| 免费99视频| 99精品国产高清一区二区| 国产成人涩涩涩视频在线观看| 国产精品露出视频| 一本久久a久久精品vr综合| 日韩高清国产一区在线观看| 黄色激情在线视频| chinese少妇国语对白| 久久久久久香蕉网| 一区二区免费电影| 欧美又大又粗又长| 国产免费毛卡片|