(c)  
Tighten the nut to 1800-2400 pound-inches. Loosen then tighten to 60 pound-inches. Move forward to the nearest lock position to install the antirotation bolt. Do not use over 2400 pound-inches (View B-B).

 S 424-015
 (3)  
Move the reaction link forward to the correct position.

 (a)  
Apply grease to the pin, the bolt, the end caps, the washer, the nut, and the cotter pin.

 (b)  
Install these parts to connect the reaction link to the support link.

 (c)  
Tighten the nut to 100-200 pound-inches (View D-D).

 S 434-016
 (4)
Connect the clamps for the hydraulic line to the reaction link.

 S 494-037

 (5)  
Install the thread protector.

 (a)  
Apply grease to the pin, the antirotation bolt, the nuts, the washers, and the cotter pin.

 (b)  
Install these parts to connect the upper side strut to the swivel.

 (c)  
Tighten the nut to 840-1080 pound-inches. Loosen the nut to the nearest lock position to install the antirotation bolt.

 F.
Put the Airplane Back to Its Usual Condition

 (1)  
Lubricate the swivel at the grease fittings.

 S 644-017
 

 32-11-07
 ALL  ú ú 01 Page 404 ú Jan 28/00
 
A
757 MAINTENANCE MANUAL
 S 584-018
 (2) Lower the airplane and remove the jacks (AMM 07-11-01/201).
 S 094-039
 WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO REMOVE THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (3)  Remove the door locks from the landing gear and close the doors (AMM 32-00-15/201).
 TASK 32-11-07-004-020
 4. Remove the Lower Side Strut Swivel of the Main Landing Gear (Fig. 401)
___________________________________________________________
 A. Equipment
 (1)  
Thread Protector Set, MLG - B32011-14

 (2)  
Crowfoot Wrenches - F70312-37, -38

 B.
References

 (1)  
AMM 07-11-01/201, Jacking Airplane

 (2)  
AMM 29-11-00/201, Pressurize/Depressurize Main Hydraulic System

 (3)  
AMM 32-00-15/201, Landing Gear Door Locks

 (4)  
AMM 32-00-20/201, Landing Gear Downlocks

 C.
Access

 (1)  
Location Zones
 731/741 Main Landing Gear (MLG)
 732/742 MLG Body Doors
 733/743 MLG Oleo Doors

 D.
Prepare to Remove the Lower Side Strut Swivel.

 S 494-021
 (1)  Make sure the downlocks are installed on the nose and main landing gear (AMM 32-00-20/201).
 S 494-040
 WARNING: USE THE PROCEDURE IN AMM/32-00-15/201 TO INSTALL THE DOOR
_______ LOCKS. THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Open the doors for the landing gear and install the door locks (AMM 32-00-15/201).

 S 864-023

 (3)  
Remove the pressure from the left hydraulic system
 (AMM 29-11-00/201).

 (4)  
Lift the airplane (AMM 07-11-01/201).

 S 584-024
 

 32-11-07
 ALL  ú ú 01 Page 405 ú May 28/99
 
A

757 MAINTENANCE MANUAL
 E. Remove the Lower Side Strut Swivel.
 S 844-025
 (1)  
Hold the side strut and downlock assembly to prevent movement.

 S 034-026

 (2)  
Remove the nut with the crowfoot wrench.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機(jī)維護(hù)手冊 起落架 CHAPTER 32 - LANDING GEAR 1(97)