-
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
R WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
_______ R - FLUSH IT AWAY WITH CLEAN WATER R - GET MEDICAL AID.
 1. Reason for the Job
__________________
 To change the type of hydraulic fluid or to change the hydraulic fluid if the contamination is out of tolerance.
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking plug No specific circuit breaker(s) safety clip(s) No specific hydraulic ground power supply (reservoir capacity
 min. 150 l.)
 No specific plug type E0052R8B3APNE
 No specific access platform 1.8 m (5 ft. 11 in.)
 DH0501 1 TOOL - HYDRAULIC FLUID CHANGE
 98D12308351000 1 LP - HOSES FOR FLUID CHANGE

 B. Consumable Materials
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
R Material No. 02-003  F NSA 307110 TYPE 4 HYDRAULIC FLUID (PHOSPHATE ESTER BASE) (Ref. 20-31-00)
 C. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
07-11-00-581-001 Lifting for Aircraft Maintenance Operations 07-11-00-586-002 Lowering of the Aircraft for Maintenance Operations 12-12-29-611-002 Fill the Hydraulic Fluid Reservoir with a Hydraulic
 Service Cart 12-32-29-281-001 Hydraulic Fluid Sample of Green,Blue and Yellow Systems for Analysis 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 29-10-00-680-001 Drainage of the Reservoir of the Green Hydraulic
 System 29-10-00-863-001 Pressurize the Green Hydraulic System 29-10-00-864-001 Depressurize the Green Hydraulic System 29-11-44-610-001 Servicing of the LP-Filter (1002GM) 29-11-45-610-001 Servicing of the HP-Filter 1048GM 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
 the Ground Connector 32-00-00-481-002 Installation of the Safety Devices on the Landing
 Gear Doors
 32-12-00-010-001 Open the Main Gear Doors for Access
 32-12-00-410-001 Close the Main Gear Doors after Access
 32-30-00-867-001 Retraction of the Landing Gear for Maintenance
 32-30-00-867-002 Extension of the Landing Gear after Maintenance
 71-00-00-710-001 Dry Motoring Check
 12-36-29-991-020 Fig. 321
 12-36-29-991-021 Fig. 322

 3. Job Set-up
__________ Subtask 12-36-29-860-124
 A. Aircraft Maintenance Configuration
 (1)
 On the Green HP manifold (1011GM), disconnect the pressure switch (1151GN) and (10CE2), and on the free end make a short circuit between the pins A and B with a plug type E0052R8B3APNE.

 (2)
 Energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-861-002).

 (3)
 On the overhead maintenance panel 50VU, make sure that the LEAK MEASUREMENT VALVES/G pushbutton switch is released (the OFF legend is on).

 Subtask 12-36-29-865-058
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU HYD/HYD PWR/B WARN/& CTL 2702GJ C12 123VU B HYD/ELEC PUMP 2701GJ AB09
 Subtask 12-36-29-010-101
 C. Get Access
 (1)
 Open the left main landing gear door (Ref. TASK 32-12-00-010-001).

 (2)
 Open the access door 197CB.

 (3) Put an access platform below the MLG bay. Subtask 12-36-29-680-054
 D. Drain the reservoir of the Green hydraulic system (Ref. TASK 29-10-00-680-001).
 1EFF : ALL 1 12-36-29Page A374 1 1 Aug 01/00R 1 1 1CES 1

 Subtask 12-36-29-860-125
 E. Aircraft Maintenance Configuration
 (1) Set the hydraulic ground power supply (reservoir capacity min. 150 l.) to the correct configuration:
 (a) Make sure that the hydraulic ground power supply reservoir is filled with new HYDRAULIC FLUIDS (Material No. 02-003).
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM SERVICING 2(140)