(2)
 On panel 114VU, make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) is installed on the flap/slat control lever.

 (3)
 Put a warning notice on the flap/slat control lever to tell persons not to operate the slats.

 1EFF : ALL 1 12-22-27Page 327 1 1 May 01/04R 1 1 1CES 1

 Slats - Lubrication Points Figure 305/TASK 12-22-27-991-002
 1EFF : 1 1R 1CES  ALL  1 11 1 12-22-27 Page 328 May 01/04

 (4) Put the access platform in position under the applicable slat track.

 Subtask 12-22-27-865-060
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 5CV B06 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 7CV R21
 Subtask 12-22-27-010-054
 D. Get Access
 (1) Remove the applicable access panels, (Ref. TASK 57-41-37-000-004) and (Ref. TASK 57-41-37-000-006):
 -
for the left wing remove 521AB, 521CB, 521EB, 522AB, 522CB, 522FB, 522KB, 522LB, 522NB, 522QB, 522SB, 522UB

 -
for the right wing remove 621AB, 621CB, 621EB, 622AB, 622CB, 622FB, 622KB, 622LB, 622NB, 622QB, 622SB, 622UB.

 4. Procedure
_________ (Ref. Fig. 305/TASK 12-22-27-991-002) Subtask 12-22-27-640-055
 A. Lubricate the Slat Track Pinion Bearings, the Slat Track Rollers, the Pinions and the Rack Teeth
 NOTE : When you do a maintenance task that uses common grease, refer to
____
 the SIL (Ref. SIL 12-008).

 1EFF : ALL 1 12-22-27Page 329 1 1 May 01/04R 1 1 1CES 1

 (1) Lubricate the pinion bearings with COMMON GREASE (Material No. 04-024) or COMMON GREASE (Material No. 04-004) as follows:
 (a) Clean the greasers with a clean MISCELLANEOUS (Material No. 19-003).
 CAUTION : IF YOU USE POWER-OPERATED LUBRICATION EQUIPMENT, DO NOT
_______ USE AN AIR SUPPLY PRESSURE OF MORE THAN 3 BARS (43.5 PSI). THE AIR PRESSURE CAUSES THE GREASE TO COME OUT OF THE EQUIPMENT WITH MORE FORCE THAN IF YOU USE MANUALLY-OPERATED EQUIPMENT. THUS IF THE AIR PRESSURE IS TOO HIGH, THE GREASE WILL POSSIBLY CAUSE DAMAGE TO THE PINION BEARING SEALS.
 (b)
 If you use power-operated lubrication equipment:

 (c)
 If you use manually-operated lubrication equipment: 1 Lubricate through the pinion bearing greasers.

 1_ Lubricate through the pinion bearing greasers at a maximum
 pressure of 3 bar (43.5 psi).
 2_ Lubricate through the greasers until new grease comes out.

_
 2 Lubricate through the greasers until new grease comes out.

_

 (2)
 Lubricate the slat track rollers with COMMON GREASE (Material No. 04-024) or COMMON GREASE (Material No. 04-004) as follows:

 (a)
 Clean the greasers with a clean MISCELLANEOUS (Material No. 19-003).

 (b)
 Lubricate the slat track rollers through the greasers until new grease comes out.

 (3)
 Remove the unwanted grease from the greasers and the slat track rollers and pinion bearings with a clean MISCELLANEOUS (Material No. 19-003).

 (4)
 Make sure that the greaser ball has seated correctly after lubrication.

 1EFF : ALL 1 12-22-27Page 330 1 1 May 01/04R 1 1 1CES 1

 (5) Lubricate the pinions and rack teeth as follows:

 (a) Lightly apply COMMON GREASE (Material No. 04-024) or COMMON GREASE (Material No. 04-004), with a brush, to the pinions and to the rack teeth as far as possible. ________
5. Close-up
 Subtask 12-22-27-410-054
 A. Close Access
 (1) Install the applicable access panels, (Ref. TASK 57-41-37-400-002) and (Ref. TASK 57-41-37-400-006):
 -
for the left wing install 521AB, 521CB, 521EB, 522AB, 522CB, 522FB, 522KB, 522LB, 522NB, 522QB, 522SB, 522UB

 -
for the right wing install 621AB, 621CB, 621EB, 622AB, 622CB, 622FB, 622KB, 622LB, 622NB, 622QB, 622SB, 622UB.

 Subtask 12-22-27-865-061
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 5CV, 7CV.
 Subtask 12-22-27-866-057
 C. Aircraft Configuration
 (1) Make sure that the work area is clean and clear of tool(s) and other items.
 (2) Retract the slats fully (Ref. TASK 27-80-00-866-005). Subtask 12-22-27-942-056
 D. Removal of Equipment
 (1)
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM SERVICING 2(8)