R Lubrication of the FWD and AFT Cargo Compartment-Door Handle R Figure 308A/TASK 12-22-52-991-014
R 1EFF : 051-052, 1 12-22-52Page 338 1 1 May 01/05 1 1 1CES 1
R **ON A/C 001-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 12-22-52-410-058-A
B. Close Access
(Ref. Fig. 308/TASK 12-22-52-991-014-A)
(1)
Put the access cover on the inner skin of the cargo door and attach it with the screws.
(2)
Install the door lining and insulation on the cargo door (Ref. TASK 52-31-13-000-001) or (Ref. TASK 52-32-13-000-001).
(3)
Remove the actuator safety locks and close the cargo door (Ref. TASK 52-30-00-860-001).
(4) Remove the access platform(s). **ON A/C 051-052,
Subtask 12-22-52-410-058
B. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Make sure that the locking handle is in the LOCKED position and push it into the recess of the handle flap.
(3)
Install the access panel 825AR or 826AR on the applicable cargo door.
(4)
Remove the access platform(s).
**ON A/C 301-399,
TASK 12-22-52-640-013
Lubrication of the External Control Handle and the Telescopic Arm
WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK AREA WHEN
_______ YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
1. Reason for the Job
__________________
Refer to the MPD TASK: 522200-03
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific grease gun No specific lint-free cloth No specific access platform 3.2 m (10 ft. 6 in.)
R 1EFF : 301-399, 1 12-22-52Page 340 1 1 May 01/05 1 1 1CES 1
B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
Material No. 04-004 USA MIL-PRF-23827 TYPE I
SYNTH.ESTER BASED GREASE HIGH PRESSURE
(Ref. 20-31-00)
Material No. 04-017 USA A-A-59173
SILICONE GREASE (Ref. 20-31-00)
Material No. 05-027 USA MIL-L-81309
RUST INHIBITOR(FOR CORROSION USE 15-004)
(Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
52-22-00-010-001 Opening of the Emergency Exit Doors from the Passenger Compartment 52-22-00-410-001 Closing of the Emergency Exit Doors from the Passenger Compartment 52-22-00-860-003 Special Precaution before Maintenance on the Door Damper and Emergency Operation Cylinder 52-22-00-860-004 Special Precaution after Maintenance on the Door
Damper and Emergency Operation Cylinder
R 12-22-52-991-020 Fig. 309
R 12-22-52-991-021 Fig. 310
3. Job Set-up
__________
Subtask 12-22-52-010-063
A. Get Access
(1)
Open the applicable emergency exit door (referred to as door) as required (Ref. TASK 52-22-00-010-001).
(2)
Make sure that the access platform is in position below the partly opened door.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM SERVICING 2(31)
