_ NOTE : This procedure will help to remove the moisture from
____ the inner surfaces of the doors.
R 1EFF : 001-049, 051-099, 101-105, 1 12-31-52Page 207 1 1 May 01/05 1 1 1CES 1
(2)
FWD, AFT and BULK Cargo-Compartment Doors (After Flight).
(a)
Remove the snow and/or slush from the subsequent areas before you close the FWD, AFT and BULK cargo-compartment doors (Ref. TASK 52-30-00-860-002) (Ref. TASK 52-30-00-860-008) :
-
the door pressure seals
-
the door contact areas on the fuselage.
(b)
If the aircraft flies from an airport where the ambient temperature is more than 0 deg.C (32.00 deg.F) to an airport where the ambient temperature is less than 0 deg.C (32.00 deg.F), you must:
(3)
Maintenance
1_ Apply the temporary protective compound, STORAGE PRESERVATION
(Material No. 15-005A) as a spray, to the subsequent areas of
the FWD, AFT and BULK cargo-compartment doors:
- the operating mechanisms
- the inner surfaces of the lower areas of the cargo doors.
NOTE : This procedure will keep the effects of freezing____
condensation to a minimum at cold airports.
NOTE : The frequency of the subsequent procedure may be increased as
____ required by the operating environment.
(a)
Make sure that the pressure seal drains of the FWD, AFT and BULK cargo-compartment doors are clear and not blocked.
(b)
Use a lint-free cotton cloth, MISCELLANEOUS (Material No. 19-003) and the CLEANING AGENTS (Material No. 11-004) to clean these components of the applicable cargo-compartment doors:
-
the pressure seals and their contact areas on the fuselage
-
the vent panel seals
-
the external operating handles
-
the door hinges and the guide fittings.
(c)
Apply the silicone grease, SPECIAL MATERIALS (Material No. 05-001) to the door frame. Apply the silicone grease, COMMON GREASE (Material No. 04-011) to the pressure seals.
(d)
Apply the silicone grease, SPECIAL MATERIALS (Material No. 05-001) to the vent panel frame. Apply the silicone grease, COMMON GREASE (Material No. 04-011) or the pure mineral vaseline, COMMON GREASE (Material No. 04-012) to the vent panel seals.
R 1EFF : 001-049, 051-099, 101-105, 1 12-31-52Page 208 1 1 May 01/05 1 1 1CES 1
(e)
Apply the temporary protective compound, STORAGE PRESERVATION (Material No. 15-005A) to the external control handles and shafts.
(f)
Lubricate the door hinges and the guide fittings. Apply the temporary protective compound, STORAGE PRESERVATION (Material No. 15-005A) to the latch assemblies and the latch spools.
R **ON A/C 106-149, 151-199, 201-299, 401-499,
Subtask 12-31-52-660-051
C. Winter Preparation (Before Flight)
(1)
On the Passenger/Crew Doors and Emergency Exit Hatches.
(a) Remove all the snow and slush from the subsequent areas before you close a passenger/crew door or an emergency exit hatch:
-
the door pressure seal
-
the seal contact area on the fuselage.
(2)
On the FWD and AFT Cargo-Compartment Doors.
CAUTION : DO NOT USE SOLVENTS THAT CONTAIN CHLORINE TO CLEAN THE
_______ EQUIPMENT (PUMP, HOSES, TANK AND FUNNEL) USED TO FILL THE IDG WITH OIL. CHLORINE CONTAMINATION OF THE OIL CAN CAUSE FAST DETERIORATION OF THE OIL AND WILL DECREASE THE LIFE OF THE IDG.
(a) Remove as much snow and/or water as possible from the cargo pallets/containers before you install them in the aircraft.
NOTE : Large quantities of melting snow and water can cause the
____ cargo-compartment doors to freeze in their closed positions.
(b)
Do not open the FWD and AFT cargo-compartment doors (Ref. TASK 52-30-00-860-001) until immediately before you install the cargo pallets/containers.
(c)
Close the FWD and AFT cargo-compartment doors (Ref. TASK 52-30-00-860-002) immediately after the installation of the cargo pallets/containers is complete.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 12-31-52Page 209 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM SERVICING 2(66)
