曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R 1. Open the protection cover and R pull up the slide control handle. R
R 2. Install the PIN - SAFETY SLIDE R (98A52107632000).
R 3. Open the handle cover and pull up R the inboard handle to the OPEN R position.
R 4. Use the assist handle and push R the door with force outboard to the R fully open position. R
R 5. Try to move the door rearwards. R
R 6. Push and hold the release button R at the support arm.
R 7. Pull the door with the assist R handle rearward until the door is in R front of the opening.
The green DISARMED label comes in view at the indication window and the escape slide-release mechanism is set to off.
The escape slide-release mechanism is safetied in the DISARMED mode.
The red UNLOCKED label comes in view at the locking indication window and the door lifts.
The door moves with a constant speed outboard and forward parallel to the fuselage until the door damper stops its movement.
The door stay mechanism blocks the door.
The door stay mechanism releases.
The door moves with a constant speed rearward parallel to the fuselage.
R 1EFF : 301-399, 1 52-22-00Page 502 1 1 May 01/04 1 1 1CES 1

R  Operation of the Emergency Exit Door 
R  Figure 501/TASK 52-22-00-991-020 
R 1EFF :  301-399,  1  52-22-00 Page 503 
1  1  May 01/04
 1  1
 1CES  1

 

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
R 8. Remove the PIN - SAFETY SLIDE and R try to push down the slide control R handle.
R 9. Install the PIN - SAFETY SLIDE.
R 10. Try to pull down the inboard R handle when the door is still R opened.
R 11. Pull the door with the assist R handle fully inboard.
R 12. Push down the inboard handle and R close the handle cover. R R
R 13. Remove the PIN - SAFETY SLIDE R and push down the slide control R handle. R
R 14. Close the protection cover. R
R Subtask 52-22-00-720-051 The movement of the slide control handle is blocked.
The movement of the inboard handle is blocked and the door does not lower.
The door moves in the correct position to the fuselage.
The door lowers into the fuselage opening and the green LOCKED label comes in view at the locking indication window.
The red ARMED label comes in view at the indication window and the escape slide-release mechanism is ready for operation.
The slide control handle is safetied for accidental operation.
R B. Functional Test of the Hand Force
R (1) Make sure that the special precaution procedure for the door damper R and emergency operation cylinder is done (Ref. TASK 52-22-00-860-R 003).
R (2) Make sure that the applicable door is closed and the slide control R handle is in the disarmed position (Ref. TASK 52-22-00-410-001).
R NOTE : Make sure that the PIN - SAFETY SLIDE is installed.
____
R (3) Put a dynamometer of 20.0 daN (44.96117 lbf.) in position on the R inboard handle. R NOTE : Make sure that the dynamometer is always at right-angle with
____ R the inboard handle during the complete test.
 1EFF : 301-399, 1 52-22-00Page 504 1 1 May 01/04 1 1 1CES 1 1EFF : 301-399, 1 52-22-00Page 505 1 1 May 01/04 1 1 1CES 1 1EFF : 301-399, 1 52-22-00Page 506 1 1 May 01/04 1 1 1CES 1

R  (4) Do this test to make sure that the hand force on the inboard handle 
R  is satisfactory during the door operation. 
R  -------------------------------------------------------------------------------
R  ACTION RESULT 
R  -------------------------------------------------------------------------------
R  1.Slowly operate the inboard handle The force must be less than 15.0 daN 
R  up and measure the force which is (33.7213 lbf) 
R  necessary to open the door. 
R  2.Slowly operate the inboard handle The force must be less than 15.0 daN 
R  down and measure the force which is (33.7213 lbf) 
R  necessary to close the door. 
R  3.Look for the differences between The differences must be less than 5.0 
R  the "open" and "close" force. daN (11.2404 lbf). 
R  (5) Make sure that the applicable door is closed and the slide control 
R  handle is in the armed position (Ref. TASK 52-22-00-410-001). 
R  Subtask 52-22-00-710-051 
R  C. Operational Test of the Door Mechanism from the Outer Side 
R  WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES._______ 
R  RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門3(62)