曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (4) Put a dynamometer of 20.0 daN (44.9617 lbf) in position on the 
R  inboard handle. 
R  NOTE : Make sure that the dynamometer is always at right-angle with____ 
R  the inboard handle during the whole measurement sequence. 
R  (5) Slowly operate the inboard handle down and measure the force which is 
R  necessary to close the door. 
R  NOTE : The force must be less than 15.0 daN (33.7213 lbf).____ 
R  (6) Slowly operate the inboard handle up and measure the force which is 
R  necessary to open the door. 
R  NOTE : The force must be less than 15.0 daN (33.7213 lbf). The____ 
R  difference between the "open" and "close" force must be less 
R  than 5.0 daN (11.2404 lbf). 
R  (7) If the force is more than permitted, turn the adjustment screw (222) 
R  clockwise to increase the tension of the torsion spring. 
R  (8) Repeat the check of the operational force again. 
R  (9) If the adjustment of the balance mechanism is correct, safety the 
R  adjustment screw (222) with lockwire, corrosion resistant steel, dia. 
R  0.8 mm (0.30 in.). 
R  5. Close-up________ 
R  Subtask 52-22-00-865-059 
R  A. Make sure that this(these) circuit breaker(s) is(are) closed: 
R  13WN, 15WN, 48WV

 1EFF : 301-399, 1 52-22-00Page 570 1 1 May 01/04 1 1 1CES 1 1EFF : 301-399, 1 52-22-00Page 571 1 1 May 01/04 1 1 1CES 1 DOOR - EMERGENCY EXIT - REMOVAL/INSTALLATION

R  Subtask 52-22-00-410-060 
R  B. Close Access 
R  (1) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  (2) Make sure that the BALLAST WEIGHT - EMERGENCY EXIT is removed and the 
R  door lining is installed (Ref. TASK 25-23-47-400-012) and (Ref. TASK 
R  25-23-47-400-013). 
R  (3) Do the special precaution on the door damper and emergency operation 
R  cylinder (Ref. TASK 52-22-00-860-004). 
R  (4) Close the door correctly (Ref. TASK 52-22-00-410-001).

 

____________________________________________
 TASK 52-22-11-000-001
 Removal of the Emergency Exit Doors
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
 No specific crane, minimum capacity 90 kg (198.4 lb.)
 No specific access platform 3.2 m (10 ft. 6 in.)
 98A52108004001 1 SLING - PASSENGER DOOR

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-23-47-000-012  Removal of the Door Linings of the LH FWD Emergency Exit Door, zone 231
 25-23-47-000-013  Removal of the Door Linings of the RH FWD Emergency Exit Door at zone 251 or RH AFT at zone 252 or LH AFT at zone 232.
 52-22-00-010-001 Opening of the Emergency Exit Doors from the Passenger Compartment 52-22-00-860-003 Special Precaution before Maintenance on the Door
 Damper and Emergency Operation Cylinder 52-22-11-991-001 Fig. 401 52-22-11-991-002 Fig. 402 52-22-11-991-003 Fig. 403 52-22-11-991-004 Fig. 404
 1EFF : 301-399, 1 52-22-11Page 401 1 1 May 01/04 1 1 1CES 1

 3. Job Set-up
__________ Subtask 52-22-11-010-050
 A. Get Access
 (1) Open the applicable emergency exit door (referred to as door) as required (Ref. TASK 52-22-00-010-001).
 NOTE : Make sure that the outboard handle is aligned with the door
____
 contour.

 (2)
 Make sure that the access platform is in position below the partly opened door.

 (3)
 Make sure that the special precaution on the door damper and emergency operation cylinder is completed (Ref. TASK 52-22-00-860-003).

 Subtask 52-22-11-865-050
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU COM/CIDS/DEU B/ESS 153RH G03 121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門3(80)