(b)
Other damage (cracks, scratches, stress, marks, dents, bumps,...):
-If you find other damage, refer to the Structural Repair Manual (Ref. SRM 511100-P.Block001) for damage classification and corrective action.
5. Close-up
________
Subtask 54-51-00-440-071
A. Aircraft Maintenance Configuration
(1) Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041). Subtask 54-51-00-410-070
B. Close Access R (1) Install the access panels:
(a)
For the left pylon: 471AL, 471BL, 471CL, 472AR, 472BR.
(b)
For the right pylon: 481AL, 481BL, 482AR, 482BR, 482CR.
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
(3)
Remove the access platform(s).
(4)
Remove the warning notice(s).
Junction Area between the Top Spar and the Lateral Panel R Figure 621/TASK 54-51-00-991-032- 12 (SHEET 1)
1EFF : ALL 1 54-51-00Page A606 1 1 Feb 01/04 1 1 1CES 1
Junction Area between the Top Spar and the Lateral Panel R Figure 621/TASK 54-51-00-991-032- 22 (SHEET 2)
1EFF : ALL 1 54-51-00Page A607 1 1 Feb 01/04 1 1 1CES 1
TASK 54-51-00-200-021
Detailed Inspection of Pylon, Upper Spars, Upper Surface, from Forward of RIB1 to RIB10
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
1. Reason for the Job
__________________
Refer to the MPD TASK: 545156-01
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific warning notice
No specific access platform 3 m (9 ft. 10 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004 USA MIL-T-81533 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM) (Ref. 20-31-00)
Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
1EFF : ALL 1 54-51-00Page A608 1 1 Feb 01/04R 1 1 1CES 1
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
36-11-42-000-001 Removal of the Bleed-Air Precooler Exchanger (7150HM1,7150HM2) 36-11-42-400-001 Installation of the Bleed-Air Precooler Exchanger (7150HM1,7150HM2) 78-30-00-081-041 Make the Thrust Reverser Serviceable after Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
Maintenance
SRM 511100-P.Block001
SRM 512200-P.Block001
R 54-51-00-991-036 Fig. 622
3. Job Set-up
__________
Subtask 54-51-00-941-071
A. Safety Precautions
(1)
On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2)
Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3)
On the overheat maintenance panel 50VU:
(a)
Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b)
Put a warning notice to tell persons not to energize the FADEC.
Subtask 54-51-00-010-067
B. Get Access
(1)
Put an access platform in position at the zone 415 (425).
(2)
Remove the access panels.
(a)
For the left pylon: 413CL, 413DL, 413EL, 414CR, 414FR, 471AL, 471BL, 471CL, 472AR, 472BR.
(b)
For the right pylon: 423CL, 423DL, 423FL, 424CR, 424ER, 481AL, 481BL, 482AR, 482BR, 482CR.
Subtask 54-51-00-020-058
C. Removal of the Component
(1)
Remove the precooler (Ref. TASK 36-11-42-000-001). Subtask 54-51-00-040-066
D. Aircraft Maintenance Configuration
(1)
Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). Subtask 54-51-00-110-072
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NACELLES/PYLONS(44)
