(5) If the solenoid electrical checks are OK, go to step (7).
(6) If the solenoid electrical checks are not OK:
- replace the applicable WTB Solenoid Valve, (Ref. AMM TASK 27-51-51-000-002) and (Ref. AMM TASK 27-51-51-400-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-51-00∞∞∞∞∞∞∞∞∞∞Page 279
May 01/05R CES
(7) If the fault continues:
- do a check and repair the aircraft wiring between the applicable SFCC 1 (2) ARINC tray interface and the applicable electrical connector 33CV-A or 33CV-B, (Ref. ASM 27-51/06) or (Ref. ASM 27-51/07).
(8) Do the test in Para. 3.A.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-51-00∞∞∞∞∞∞∞∞∞∞Page 280
May 01/05R
CES FLP RH WTB BLU Solenoid 34CV or Open or Short Circuit to SFCC 1 FLP RH WTB GRN Solenoid 34CV or Open or Short Circuit to SFCC 2
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
- THE FLIGHT CONTROLS
- THE FLIGHT CONTROL SURFACES
- THE LANDING GEAR AND THE RELATED DOORS
- COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE
_______ CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
1. Possible Causes
_______________
- SFCC-1 (21CV)
- SFCC-2 (22CV)
- BRAKE-R WING TIP (34CV)
- A/C wiring between SFCC 1 ARINC tray interface and the electrical
connector
- 34CVA
- A/C wiring between SFCC 2 ARINC tray interface and the electrical
connector
- 34CVB
- WTB solenoid valve
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific Multimeter No specific 45Vdc Isolation Tester
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-51-00∞∞∞∞∞∞∞∞∞∞Page 281
May 01/05R
CES
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 27-51-00-740-002 Bite Test of the Slat and Flap Control Computers
(Flap System) AMM 27-51-34-000-001 Removal of the SFCC (21CV,22CV) AMM 27-51-34-400-001 Installation of the SFCC (21CV,22CV) AMM 27-51-51-000-002 Removal of the Solenoid Valves of the Flap Wing-Tip
Brake (WTB)
AMM 27-51-51-400-002 Installation of the Solenoid Valves of the Flap
Wing-Tip Brake (WTB)
ASM 27-51/06
ASM 27-51/07
3. Fault Confirmation
__________________
A. SFCC System Bite WTB Solenoid test
(1) Do a BITE test on the SFCC 1 (2) (Ref. AMM TASK 27-51-00-740-002). The fault data "RH WTB solenoid open circuit (disconnect)" is displayed, or the fault data "RH WTB solenoid short circuit" is displayed.
(2) Do the fault isolation.
4. Fault Isolation
_______________
A. Procedure.
(1) Swap the SFCC 1 and SFCC 2 (Ref. AMM TASK 27-51-34-000-001) for (Ref. AMM TASK 27-51-34-400-001) do Para.2,3 and 4 only.
(a) Access the FLP ON GROUND FAULTS and do a check of the ground log.
(2) If the fault moves with SFCC 1(2).
(3) Install the SFCC 1 (2) in their initial locations.
- replace the unserviceable SFCC-1 (21CV) (SFCC-2 (22CV)) Ref.Para 4.A.(1).
(4) If the fault continues:
(a) find electrical connector for the BRAKE-R WING TIP (34CV) solenoids and release.
(5) Do a check of the A/C wiring between SFCC 1 ARINC tray interface and the electrical connector (Ref. ASM 27-51/06) 34CVA (BLUE solenoid)
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-51-00∞∞∞∞∞∞∞∞∞∞Page 282
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 飛行操縱 2(8)
