曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 -replace the XDCR-BLEED REGULATED PRESS, ENG 1 (8HA1) (Ref. AMM TASK 36-11-16-000-001) and (Ref. AMM TASK 36-11-16-400-001).
 (a) If the fault continues:
 -replace the XDCR-BLEED TRANSFER PRESS, ENG 1 (7HA1) (Ref. AMM TASK 36-11-15-000-001) and (Ref. AMM TASK 36-11-15-400-001).
 1
 -EFF : ALL

-∞∞36-11-00∞∞∞∞∞∞∞∞∞∞Page B221
 --Feb 01/05R ---CES -

 

 Drift of the Pressure Transducer on the Engine 2
 1. Possible Causes_______________
 -
XDCR-BLEED REGULATED PRESS, ENG 2 (8HA2)

 -
XDCR-BLEED TRANSFER PRESS, ENG 2 (7HA2)

 2. Job Set-up Information______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
AMM 36-11-00-710-002  Operational Test to Read the CLASS III FAULTS
 AMM 36-11-15-000-001  Removal of the Bleed Transferred Pressure Transducer (7HA1,7HA2)
 AMM 36-11-15-400-001  Installation of the Bleed Transferred Pressure Transducer (7HA1,7HA2)
 AMM 36-11-16-000-001  Removal of the Bleed Regulated Pressure Transducer (8HA1,8HA2)
 AMM 36-11-16-400-001  Installation of the Bleed Regulated Pressure Transducer (8HA1,8HA2)
 3. Fault Confirmation__________________
 A. Test
 (1) Not Applicable
 4. Fault Isolation_______________
 A. Do the operational test to read the class III faults of the BMC (Ref. AMM TASK 36-11-00-710-002)
 (1)
 If the operational test gives the maintenance message:
 DRIFT REG-PRESS XDCR 8HA2

 -replace the XDCR-BLEED REGULATED PRESS, ENG 2 (8HA2) (Ref. AMM TASK 36-11-16-000-001) and (Ref. AMM TASK 36-11-16-400-001).

 (2)
 If the operational test gives the maintenance message:
 DRIFT TRANSF-PRESS XDCR 7HA2

 

 -replace the XDCR-BLEED TRANSFER PRESS, ENG 2 (7HA2) (Ref. AMM TASK 36-11-15-000-001) and (Ref. AMM TASK 36-11-15-400-001).
 1
 -EFF : ALL

-∞∞36-11-00∞∞∞∞∞∞∞∞∞∞Page B222

 --Feb 01/05R ---CES -

 

 (3) If the operational test does not gives the above maintenance message:
 -replace the XDCR-BLEED REGULATED PRESS, ENG 2 (8HA2) (Ref. AMM TASK 36-11-16-000-001) and (Ref. AMM TASK 36-11-16-400-001).
 (a) If the fault continues:
 -replace the XDCR-BLEED TRANSFER PRESS, ENG 2 (7HA2) (Ref. AMM TASK 36-11-15-000-001) and (Ref. AMM TASK 36-11-15-400-001).
 1
 -EFF : ALL

-∞∞36-11-00∞∞∞∞∞∞∞∞∞∞Page B223
 --Feb 01/05R ---CES -

 

 Failure of the Bleed Pressure Regulator Valve Control Solenoid or its Wiring
 1. Possible Causes
_______________

 -SOLENOID-BLEED PRESS REG V CTL, ENG 1 (10HA1)
 -P/BSW-ENG 1 BLEED (4HA1)
 -SOLENOID-BLEED PRESS REG V CTL, ENG 2 (10HA2)
 -P/BSW-ENG 2 BLEED (4HA2)
 -wiring

 -
C/B-AIR BLEED/ENG 1/CTL (3HA1)

 -
C/B-AIR BLEED/ENG 2/CTL (3HA2)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R 24-00-00-810-803 Circuit Breaker Tripped and/or C/B TRIPPED Warning AMM 36-11-55-000-001 Removal of the Bleed-Pressure-Regulator Valve Control-Solenoid (10HA1,10HA2) AMM 36-11-55-400-001 Installation of the Bleed-Pressure-Regulator Valve
 Control-Solenoid (10HA1,10HA2)
 ASM 36-11/01
 ASM 36-11/02

 3. Fault Confirmation
__________________
 A. Test.

 (1) Not applicable.
 4. Fault Isolation
_______________

 A. Table of the circuit breakers used in this procedure:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AIR BLEED/ENG 1/CTL 3HA1 D12 122VU AIR BLEED/ENG 2/CTL 3HA2 Z23
 1 -EFF : ALL

-∞∞36-11-00∞∞∞∞∞∞∞∞∞∞Page B224
 --May 01/05 ---CES -

 B. If the fault symptom is identified by the status message ONE PACK ONLY IF WAI ON: - on the overhead circuit breaker panel 49VU, do a check of the status of
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 PNEUMATIC(93)