(d)  
Disconnect the wires from the studs.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 24-41-11
 ALL  ú ú 03 Page 401 ú Mar 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
BOLTS (3)
A 737-300/400/500MAINTENANCE MANUAL
EXTERNAL 
EXTERNAL  POWER  INTERPHONE 
POWER 
RECEPTACLE  CONN  FLIGHT  SERVICE 
(EXAMPLE)  PILOT  ON NOSE WHEELWELL 
ELECTRONIC COMPARTMENT  SEE  A  BOLTS (4)  NOT IN USE  CALL  LIGHT NORM 
ACCESS DOOR 
SEE  B  RECEPTACLE EXTERNAL POWER 

SAFETY GUIDE
CONDUCTOR GUARD
A
PRESSURE FILLER
BRACKET SEAL
STUDS  LEADS (6)
BRACKET
EXTERNAL POWER RECEPTACLE
EXTERNAL POWER RECEPTACLE PAN
B
External Power Receptacle Component Location Figure 401
ACCESS PANEL, 1101
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 24-41-11
 ALL  ú ú 01 Page 402 ú Nov 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 024-007
 (6)  Remove the external power receptacle:
 (a)  
Remove the nuts, the bolts, and the washers that attach the receptacle to the receptacle pan.

 (b)  
Remove the external power receptacle and the safety guide from the outer side of the airplane.

 TASK 24-41-11-404-008
 3.  External Power Receptacle Installation______________________________________
 A. Consumable Materials
 (1)  
A00000 Sealant - BMS 5-93, Class B

 (2)  
A00247 Sealant - BMS 5-95 (Optional)

 (3)  
D00015 Grease

 B.
References

 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 51-31-00/201, Seals and Sealing

 C.
Access

 (1)  
Location Zone
 202 Lower Nose Compartment

 (2)  
Access Panel
 1101 External Power Receptacle Door

 D.
Install the External Power Receptacle

 S 424-009
 (1)  Install the external power receptacle:
 (a)  Put the external power receptacle and the safety guide in their positions in the receptacle pan.
 NOTE: Do this step out of the airplane.
____
 (b)  
Install the four bolts and the four washers through the receptacle, the receptacle pan, and the insulation plate.

 (c)  
Tighten the four nuts.

 S 394-015
 (2)  
Apply a pressure seal with the sealant around the receptacle (AMM 51-31-00/201).

 (3)
Connect the electrical wires to the external power receptacle:

 S 434-010
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 24-41-11
 ALL  ú ú 03 Page 403 ú Mar 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 CAUTION: MAKE SURE YOU CONNECT THE CORRECT ELECTRICAL WIRE TO EACH
_______ RECEPTACLE STUD. AN INCORRECT INSTALLATION CAN CAUSE A MALFUNCTION OF THE CIRCUIT AND DAMAGE TO THE EQUIPMENT.
 (a)  Install the six wires on the receptacle studs of the external power receptacle.
 CAUTION: DO NOT INSTALL THE WASHERS BELOW THE EXECTRICAL WIRES.
_______ THIS WILL CAUSE HEAT THAT CAN BURN THE RECEPTACLE STUDS.
 (b)  
Install the nuts and the washers on the receptacle studs as shown in Fig. 402.

 (c)  
Torque the 3/8 inch nuts (pins A, B, C and D) to 120-125 pound-inches.

 (d)  
Torque the 10/32 nuts (pins E and F) to 20-22 pound-inches.

 (e)  
Remove the identification tags.

 S 414-011
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 電源 ELECTRICAL POWER(159)