(2)
AMM 12-40-00/201, Cleaning and Washing
(3)
AMM 24-22-00/201, Manual Control
D. Access
(1) Location Zones
216 Left Main Wheel Well
217 Right Main Wheel Well
E. Procedure
S 642-061
(1) Lubricate the O-rings and the threaded fittings with assembly lube or hydraulic fluid.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
29-15-34
ALL ú ú 03 Page 211 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 432-062
(2)
Install the O-ring and the union in the inlet port of the case drain filter.
S 432-063
(3)
Install the O-ring and the check valve in the outlet port of the case drain filter.
S 422-064
(4)
Put the case drain filter in its position.
NOTE: The arrow on the filter must point in the same direction as
____
the arrow on the airplane.
S 422-065
(5)
Install the bolts to attach the case drain filter to the airplane.
S 432-066
(6)
Make sure the filter bowl has lockwire installed.
S 612-067
(7)
Fill the applicable hydraulic reservoir (AMM 12-12-00/301).
F. Leak Check for the Case Drain Filter
S 862-068
(1)
Supply electrical power (AMM 24-22-00/201).
S 862-069
(2)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:
(a) P6 panel
1) STBY HYD PUMP NORMAL
2) STBY HYD PUMP (ALT)
3) ELEC HYD PUMP CONT SYS A
4) ELEC HYD PUMP CONT SYS B
S 792-070
WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. THE AILERONS, RUDDER, ELEVATORS, FLAPS, SLATS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
(3) To look for leakage at the case drain filter for the standby EMDP, do these steps:
(a)
Put the FLT CONTROL A or the FLT CONTROL B switch in the STDBY RUD position.
(b)
Make sure the case drain filter does not have a leak.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
29-15-34
ALL ú ú 04 Page 212 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(c) Put the FLT CONTROL switch in the ON position.
S 792-071
(4) To look for leakage at the case drain filter for the system A or system B EMDP, do these steps:
(a)
Put the applicable switch, on the P5 panel, in the ON position. 1) ELEC 2 for system A. 2) ELEC 1 for system B.
(b)
Make sure the case drain filter does not have a leak.
(c)
Put the ELEC 2 or ELEC 1 switch in the OFF position.
S 862-072
(5) Remove electrical power if it is not necessary (AMM 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
29-15-34
ALL ú ú 02 Page 213 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
HYDRAULIC SYSTEMS A AND B RESERVOIRS - REMOVAL/INSTALLATION
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 液壓 HYDRAULIC POWER(107)
