曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (3)  Carefully push the lens on the raceway.
 NOTE: When you install a lens with an arrow, make sure you point
____ point the arrow in the correct direction. When you install a colored lens, make sure you install it in the correct location.
 D. Lamp Test
 S 862-010
 (1)  At the overhead panel, P5, or the attendant's panel, set the emergency lights switch to the on position.
 NOTE: Keep a record of the time that the emergency lights are on.
____
 (a)  In the least possible time, make sure the new lamp comes on correctly.
 S 862-006
 (2)  
Quickly set the switch to the usual position.

 S 862-007

 (3)  
If it is necessary, charge the batteries for the emergency lights (AMM 33-51-51/201).

 TASK 33-51-81-002-029
 3.  Aisle Locator Light - Removal (Fig. 201)_____________________________
 A. General
 (1)  This task only removes an aisle locator light. The raceway is not removed from the floor.
 B. References
 (1)  
SSM 33-51-00

 (2)  
WDM 33-51-41 thru 33-51-99

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FLOOR ú

 33-51-81
 PROXIMITY EMERGENCY LIGHTS  ú ú 01 Page 203 ú Nov 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 C.
D.
E.
F.
A
737-300/400/500MAINTENANCE MANUAL
Equipment
 (1)
Plastic ChiselConsumable Materials

 (1)
B00148 Methyl Ethyl Ketone (MEK) (AMM 20-30-31/201)Access

 (1)  
Location Zone

 100 Upper Half of FuselageProcedure
 S 032-008
 (1)  Lift up the edge of the lens and remove it from the raceway.
 NOTE: Each lens with an arrow must be installed again with the
____ arrow pointed in the correct direction. Each colored lens must be installed in the correct location. Before you remove a lens with an arrow, identify the direction of the arrow. Before you remove a colored lens, identify its location.
 S 012-053
 (2)  
For each cover that is next to the light assembly and not next to an end cap, lift up the edge of the cover and remove it to access the electrical connectors in the raceway.

 S 012-054

 (3)  
For each cover that is next to the light assembly and next to an end cap, do these steps to remove the cover:

 (a)  
If the cover is not glued to the raceway, lift up the edge of the cover and remove it to access the electrical connectors in the raceway.

 (b)  
If the cover is glued to the raceway, do these steps to remove the cover:

 

 WARNING: DO NOT GET SOLVENTS IN YOUR MOUTH, OR YOUR EYES, OR
_______ ON YOUR SKIN. DO NOT BREATHE THE FUMES FROM SOLVENTS. SOLVENTS ARE HAZARDOUS MATERIALS. SOLVENTS MAY BE FLAMMABLE OR HARMFUL TO THE ENVIRONMENT. REFER TO PRODUCT MATERIAL SAFETY DATA SHEETS (MSDS) AND LOCAL REQUIREMENTS FOR PROPER HANDLING PROCEDURES.
 1)  Apply a small amount of MEK , isopropyl alcohol, ethyl alcohol, CDG-110, or CDG-211 to a cloth and rub the cloth against a flange that is between the raceway and the cover.
 2) Position the head of the plastic chisel against a flange that is between the raceway and the cover. 3) Gently tap the plastic chisel to lift the edge of the cover. 4) Repeat the above three steps until you can remove the cover to access the electrical connectors in the raceway.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FLOOR ú

 33-51-81
 PROXIMITY EMERGENCY LIGHTS  ú ú 01 Page 204 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 022-010
 (4)  
Disconnect each electrical connector that goes to and from the aisle locator light.

 S 022-011

 (5)  
Pull out the aisle locator light to remove it.

 TASK 33-51-81-402-031
 4. Aisle Locator Light - Installation (Fig. 201)
__________________________________
 A. General
 (1)  This task installs an aisle locator light into the raceway on the floor.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(113)