33-42-31
 ALL  ú ú 01 Page 507 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL

LOCATION OF THE TARGET FOR THE LEFT INBOARD LANDING LIGHT
(RIGHT LIGHT IS SYMMETRICAL)

A TARGET IS A MARK OR AN OBJECT THAT IDENTIFIES A LOCATION ON THE GROUND
Inboard Landing Lights (Adjustment with a Target) Figure 503
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-31
 ALL  ú ú 01 Page 508 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 WARNING:_______DO NOT TOUCH THE HOT LAMP WITH YOUR BARE HANDS. A HOT LAMP CAN BURN YOUR SKIN.
 (b)  
Turn the adjustment screws of the inboard landing light until the center of the light beam is on the target.

 (c)  
Set the switch for the landing light to the off position.

 S 945-006
 (8)  
Remove the target.

 S 435-005

 (9)  
Install the lens for the inboard landing and runway turnoff lights (AMM 33-42-21/401).

 S 865-045
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
_______ LEADING EDGE FLAP AND SLAT LOCKS CORRECTLY. THE LEADING EDGE FLAPS AND SLATS CAN MOVE QUICKLY IF YOU DO NOT REMOVE THE LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (10)
 Do this task:  "Leading Edge Flap and Slat Locks Removal" (AMM 27-81-00/201).

 S 865-046

 (11)
 Remove the electrical power if it is not necessary (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-42-31
 ALL  ú ú 01 Page 509 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 RUNWAY TURNOFF LIGHTS - MAINTENANCE PRACTICES
_____________________________________________
 1.  General_______
 A.  This procedure contains the task for the replacement of the lamp in the runway turnoff landing light (referred to as the light).
 B.  The runway turnoff lights give lighting to turn the airplane.
 C.  Each runway turnoff light is adjacent to an inboard landing light. The two lights are behind one lens.
 D.  The runway turnoff lights are in a fuel vapor area. Each lamp, electrical connection, and lens has a seal to stop all fuel fumes and water.
 TASK 33-42-41-962-001
 2.  Runway Turnoff Lights Lamp Replacement (Fig. 201)______________________________________
 A.  Consumable Materials
 (1)  
B00148 Solvent - Methyl Ethyl Ketone, TT-M-261 (Optional)

 (2)  
G02186 Tape - Silicone Foam, BMS1-68F Form III

 B.  References
 (1)  
AMM 20-10-47/201, Seal the Open Terminals in the Fuel Vapor Areas

 (2)  
24-22-00/201, Manual Control

 (3)  
27-81-00/201, Leading Edge Flap and Slat Locks Installation

 (4)  
33-42-21/401, Inboard Landing and Runway Turnoff Light Lens Assembly (Cover) - Removal/Installation

 C.  Access
 (1)  Location Zone 303 Left Wing Inboard Leading Edge Including Slats 403 Right Wing Inboard Leading Edge Including Slats
 D.  Procedure
 S 862-002
 (1)  Prepare the light.
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO
_______ INSTALL THE LEADING EDGE FLAP AND SLAT LOCKS CORRECTLY. THE LEADING EDGE FLAPS AND SLATS CAN MOVE QUICKLY IF YOU DO NOT INSTALL THE LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (a)  
Do this task: "Leading Edge Flap and Slat Locks Installation" (Ref 27-81-00/201).

 (b)  
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 1)  P18-3 Load Control Center - Left a) RIGHT RUNWAY TURNOFF b) LEFT RUNWAY TURNOFF

 (c)  
Remove the inboard landing and runway turnoff light lens (Ref 33-42-21/401).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燈 LIGHTS(67)