S 117-022
(7)
Do steps (5) and (6) again until the compartment and/or conveyor system equipment are clean.
S 177-023
(8)
Flush the compartment and/or conveyor system equipment with warm, clean water.
NOTE: Apply the water with a mop, cloth wiper, and/or sponge, as
____ necessary.
S 147-024
(9) Remove the water with a vacuum cleaner, mops, cloth wipers, and/or sponges, as necessary.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-50-00
ALL ú ú 02 Page 708 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 147-025
(10) Dry all the surfaces cleaned with clean, cloth wipers.
NOTE: Use compressed air to remove water which is caught in hard
____
to reach areas.
S 427-026
(11) Install the conveyor system equipment you removed, if necessary.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-50-00
ALL ú ú 02 Page 709 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
COUNTERBALANCE
STRUT
ASSEMBLY HANDRAIL (2 LOCATIONS)
SEE B SEE A
LATCH LADDER
LEVER TRUNNION
SEE C
LADDER FLOOR LATCH
FOOT
EXTENDED POSITION RETRACTED POSITION
CREW LADDER
UPPER
HANDRAIL
LADDER
ENCLOSSURE
(REF)
BOLT
WASHER
BOLT NUT
WASHER (2 LOCATIONS)
BUSHING
NUT
COUNTERBALANCE
BOLT(2 LOCATIONS)LADDER
WASHER SUPPORT STRUT
(2 LOCATIONS) LOWER FWDBUSHING HANDRAIL NUT (REF)
FWD FWD
COUNTERBALANCE STRUT HANDRAIL ASSEMBLY LADDER TRUNNION
A B C
Crew Ladder Installation
Figure 401
C31410
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú
25-50-01
ú ú 02 Page 401 ú Jun 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
CREW LADDER - REMOVAL/INSTALLATION
__________________________________
1. General_______
A. This procedure contains these tasks:
(1)
The removal of the crew ladder.
(2)
The installation of the crew ladder.
B. It is recommended that two or more crews are needed for the
removal/installation of the crew ladder.
TASK 25-50-01-004-001
2. Remove the Crew Ladder (Fig. 401)______________________
A. Equipment
(1) Ladder tool
B. Access
(1) Location Zone
831L No. 1 Main Door
C. Procedure
S 864-002
(1)
Make sure the crew ladder is in the retracted position.
S 034-003
(2)
Disconnect the bolts, washers, and nuts to remove the counterbalance strut from the crew ladder.
S 044-003
WARNING: BE CAREFUL WHEN YOU LOWER THE CREW LADDER TO THE MAIN DECK.
_______ THE CREW LADDER IS VERY HEAVY AFTER YOU DISCONNECT THE COUNTERBALANCE STRUT FROM THE CREW LADDER. IF YOU ARE NOT CAREFUL THE LADDER CAN FALL AND CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(3)
Use the ladder tool to lower the crew ladder to the main deck floor.
S 034-004
(4)
Remove the bolts, washers, bushings, and nuts to disconnect the upper hand rails from the lower hand rails.
S 034-005
中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(106)
