(4)  
AMM 25-32-00/501, Upper Deck Galleys

 (5)  
AMM 26-13-00/501, Lavatory Smoke Detection System

 (6)  
AMM 38-15-00/201, Water System Pressurization

 (7)  
AMM 53-21-02/401, Main and Upper Deck Floors

 (8)  
WDM 25-31-11

 (9)  
WDM 25-31-21

 (10)
 WDM 25-31-31

 (11)
 WDM 25-31-41

 (12)
 SSM 25-31-01, 25-31-02, 25-31-03, 25-31-04

 D. Access
 (1)  Location Zone
 223 Fwd Upper Deck Passenger Cabin LH

 E. Procedure
 S 214-047
 (1)  Examine the galley floor, the floor attach fittings and the related area for damage and corrosion.
 (a)  Repair the water seal if it is damaged or worn.
 S 414-128
 (2)  
Repair damaged floor attach fittings and floor panels if it is necessary (AMM 53-21-02/401).

 (3)  
Move the galley components to the upper deck area.

 S 864-123
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-32-01
 ALL  ú ú 14 Page 407 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 344-049

 (4)  Seal the galley units:
 (a)  The galley compartments that contain moisture (coffeemakers, ovens, refrigerators, etc.) must be sealed.
 NOTE: The sealant will prevent the leakage into the adjacent
____ compartments or into the galley unit structure. Do not seal the specified drain holes.
 (b)  
The galley work areas must be sealed to prevent leakage into the lower parts of the galley.

 (c)  
The joints must be sealed to prevent the leakage of liquids between the structural walls and components.

 (d)  
The work area must be sealed to keep moisture from the space between the galley and the airplane wall.

 S 344-050
 (5)  Make a rubber seal with RTV 174 around the lower edge of the panels which touch the splashguards.
 S 424-223
 CAUTION: LOCATE THE GALLEY UNIT TO THE ATTACHMENT FITTINGS WITH
_______ SUFFICIENT CARE TO AVOID DAMAGE TO THE WATER BARRIER. ENSURE THAT ALL VENTS, WATER LINES, AND ELECTRICAL WIRES ARE CLEAR OF THE UNIT.
 (6)  
Use the vacuum cups to move the bottom section of the galley unit into its position on the floor attach fittings.

 S 864-243

 (7)  
Make sure the splashguards touch the splashguard coverplate that attaches around lower edges of the galley.

 S 424-196

 (8)  
Install the fasteners in the floor attach fittings.

 S 424-233

 (9)  
Connect the chiller drain hose to the drip tray below the chiller unit.

 S 424-234

 (10)
 Install the chiller unit in its position on the outboard side of the galley unit.

 S 424-235

 (11)
 Connect the refrigeration ducts to the chiller unit and galley if it is applicable.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-32-01
 ALL  ú ú 14 Page 408 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 424-211
 (12)
 Make sure the splashguards of the gutter drain system touch the splashguard coverplate that attaches around the lower edges of the galley.

 S 424-212

 (13)
 Install the fasteners in the floor attach fittings.

 S 424-236

 (14)
 Install the fasteners along the separation points of each of the galley sections.

 S 424-237

 (15)
 Connect the overhead tie-rod to the airplane structure.

 NOTE:____Install the tie-rod and adjust to the necessary length. The last adjustment must put the drain hole on the bottom. Put the tie-rod in the center of the clevis fitting. Install washers between the pin and the fitting, if it is necessary.
 S 284-070
 (16)
 Make sure the refrigeration thermostats and electrical connections are installed correctly if it is applicable.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(94)