S 014-077
 (2)  
Open the nose radome (AMM 53-52-01/201).

 S 424-126

 (3)  
Remove the dust caps from the waveguide flanges and the antenna waveguide connection.

 NOTE: Replace the gaskets if they are defective.
____
 S 424-079
 (4)  Install waveguide Section 1:
 (a)  
Install the screws and washers with gaskets in the flanges between waveguide Sections 1 and Section 2.

 (b)  
Attach the quick disconnect with a gasket between the waveguide Section 1 and the antenna waveguide.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-43-04
 ALL  ú ú 06B Page 411 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (c)  
Install the support clamp on the waveguide Section 1.

 (d)  
Tighten the screw and nut that attach the support clamp to the waveguide bracket.

 S 414-131
 (5)  Close the radome temporily (AMM 53-52-01/201) until after the weather radar test ND display test is done:
 NOTE: The radome is closed to prevent equipment damage from wind
____
 or rain.

 (a)  
Move the radome to the closed position.

 (b)  
Engage two of the six latch hooks.

 S 734-130
 (6)  Do the weather radar ND Display Test listed below in the Weather Radar System Test.
 D. Waveguide Section 2 Installation.
 NOTE: To install waveguide section 2, access is necessary
____ to get into the nose radome and below the compartment floor in the nose cargo door section.
 S 864-081
 (1)  
Make sure these circuit breakers are open with DO-NOT-CLOSE tags attached:

 (a)  P7 Overhead Circuit Breaker Panel
 1) 7C7 WXR L RT
 2) 7C19 WXR R RT

 (2)  
Open the nose radome (AMM 53-52-01/201).

 S 014-243

 (3)  
Get access to section 2 below the compartment floor:

 S 014-082
 (a) Release the 18 fasteners that hold the cargo floor panel.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-43-04
 ALL  ú ú 06B Page 412 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 WARNING: STEP ONLY ON THE FLOOR BEAMS WHEN YOU REMOVE CARGO FLOOR
_______ PANEL. THE FLOOR PANELS BETWEEN THE BEAMS CAN FLEX AND CAUSE YOU TO FALL. IF YOU DO NOT OBEY THESE INSTRUCTIONS, INJURY TO PERSONNEL AND/OR DAMAGE TO THE WEATHER RADAR EQUIPMENT OR BLANKET MATERIAL CAN OCCUR.
 WARNING:_______THE CARGO FLOOR PANEL IS HEAVY. TO PREVENT INJURY, TWO PEOPLE ARE REQUIRED WHEN LIFTING OR MOVING THE CARGO FLOOR PANEL.
 CAUTION: DO NOT PUSH OR PULL THE CARGO FLOOR PANEL ACROSS THE FLOOR
_______ BEAMS. THIS ACTION CAN CAUSE DAMAGE TO THE BLANKET MATERIAL.
 (b)  Carefully remove the cargo floor panel.
 S 424-133
 (4)  Remove the dust caps from the waveguide flanges.
 NOTE: Replace gaskets if they are defective.
____
 S 424-085
 (5)  Install waveguide section 2:
 (a)  
Put section 2 into the airplane through the bulkhead hole.

 (b)  
Hold section 2 and put waveguide tabs on aft and forward support brackets.

 (c)  
Attach section 2 to each support bracket with two screws, two nuts and four washers.

 (d)  
Tighten the screws only enough to hold the waveguide.

 (e)  
Install gasket on bulkhead and tighten eight screws.

 (f)  
Install screws and lockwashers with gaskets between sections 2 and 3.

 (g)  
Install screws and lockwashers with gaskets between sections 3 and 4.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 2(139)