34-24-01
ALL ú ú 01 Page 403 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
STATIC INVERTER/ILS PROCESSOR - REMOVAL/INSTALLATION
____________________________________________________
1. General_______
A. This procedure contains two tasks. The first task is for the removal of the static inverter/ILS processor. The second task is for the installation of the inverter/ILS processor.
B. The B339 static inverter/ILS processor is installed in the main equipment center on shelf No. 3 of the E1 electronics equipment rack.
TASK 34-24-02-004-001
2. Remove The Static Inverter/ILS Processor________________________________________
A. References
(1)
AMM 06-09-01/201, Body Section 41 Access Doors and Panels
(2)
AMM 20-11-22/401, Electrical/Electronic Black Box
B. Access
(1)
Location Zones 117 Electrical and Electronics Compartment, LH
(2)
Access Panels
117AL Electronics Compartment Access Door
C. Remove the Static Inverter/ILS Processor
S 864-002
(1) Open these circuit breakers and attach the DO-NOT-CLOSE tags:
(a) P7 Overhead Circuit Breaker Panel
1) 7A6 NAV RADIO ILS L
2) 7B24 STBY INSTR ILS IND
3) 7B25 STBY INSTR ATTD IND
S 014-014
(2) Open the 117AL access door to the electronics compartment to get to the static inverter/ILS processor (AMM 06-09-01/201).
S 024-013
CAUTION: DO NOT TOUCH THE STATIC INVERTER/ILS PROCESSOR BEFORE YOU
_______ CONNECT THE GROUND STRAP BETWEEN YOUR WRIST AND THE ELECTROSTATIC GROUND JACK. ELECTROSTATIC DISCHARGE CAN CAUSE DAMAGE TO THE STATIC INVERTER/ILS PROCESSOR.
(3) Remove the static inverter/ILS processor (AMM 20-11-22/401).
TASK 34-24-02-404-004
3. Install The Static Inverter/ILS Processor_________________________________________
A. References
(1)
AMM 06-09-01/201, Electronics Compartment Access Doors and Panels
(2)
AMM 20-11-22/401, Electrical/Electronic Black Box
(3)
AMM 24-22-00/201, Manual Control
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-24-02
ALL ú ú 01 Page 401 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
(4) AMM 34-31-00/501, ILS Navigation System
B. Access
(1)
Location Zones
117 Electrical and Electronics Compartment, LH
(2)
Access Panels
117AL Electronics Compartment Access Door
C. Install the Static Inverter/ILS Processor
S 864-005
(1) Make sure these circuit breakers are open with the DO-NOT-CLOSE-TAGS attached:
(a) P7 Overhead Circuit Breaker Panel
1) 7A6 NAV RADIO ILS L
2) 7B24 STBY INSTR ILS IND
3) 7B25 STBY INSTR ATTD IND
S 404-011
CAUTION: DO NOT TOUCH THE STATIC INVERTER/ILS PROCESSOR BEFORE YOU
_______ CONNECT THE GROUND STRAP BETWEEN YOUR WRIST AND THE ELECTROSTATIC GROUND JACK. ELECTROSTATIC DISCHARGE CAN CAUSE DAMAGE TO THE STATIC INVERTER/ILS PROCESSOR.
(2)
Install the static inverter/ILS processor (AMM 20-11-22/401).
S 864-007
(3)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:
(a) P7 Overhead Circuit Breaker Panel
1) 7A6 NAV RADIO ILS L
2) 7B24 STBY INSTR ILS IND
3) 7B25 STBY INSTR ATTD IND
S 864-008
(4)
Supply the electrical power (AMM 24-22-00/201).
S 714-009
(5)
Do a test of the static inverter/ILS processor:
(a)
Tune to an ILS frequency (AMM 34-31-00/501).
(b)
Set the mode selector switch on the standby attitude/ILS indicator to APP.
(c)
Do a left ILS receiver self-test (AMM 34-31-00/501)
(d)
Make sure the conditions that follow occur on the standby attitude/ILS indicator: 1) G/P and LAT flags show for approximately 3 seconds. 2) G/P and LAT flags retract from view for approximately 2
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 2(18)
