06 - COMPLETION STANDARDS
.
Establishes immediately a safe flight path.

.
Makes correct analysis and carries out procedure.

.
Ensures strict application of task-sharing and good crew communications.

.
Makes appropriate decision according to outcome of relight attempt.

07 - COMMON ERRORS
.
Incorrect speed choice and lack of monitoring.

.
Confusion with ELEC EMER CONFIG.

.
Lack of situational awareness.

.
APU started too late.

.
Engine relight not monitored (stopwatch/parameters).

.
Lack of communication.

A319/A320/A321 FLIGHT CREW TRAINING MANUAL  ABNORMAL OPERATION BRIEFINGS POWER PLANT  1.03.70  Page 8 
REV 21  MAY 98 

01 - TRAINING OBJECTIVE
.  
To understand the consequences and differences related to thrust lever malfunctions.

.  
To ensure continued safe flight and landing by applying correct procedures.

02 - SCHEDULE
Briefing duration : 10 minutes
03 - EQUIPMENT
DOC references :
.  
FCOM 1.70.30 (Thrust control)

.  
FCOM 3.02.70 (Abnormal procedure)

04 - INSTRUCTOR’S ACTIONS
Briefing of the following key points.
MAIN
.  
Differences between "Disagree" and "Fault" and related thrust control consequences.

.  
Importance of PF not being distracted by failure.

SECONDARY

.  
Caution relating to thrust lever Fault during take-off.
(on ground, between V1 and VR : warning inhibited)

A319/A320/A321 FLIGHT CREW TRAINING MANUAL  ABNORMAL OPERATION BRIEFINGS POWER PLANT  1.03.70  Page 9 
REV 21  MAY 98 

05 - TRAINEES’ ACTIONS
DISAGREE
This failure occurs when the two validated thrust lever angle signals are not in agreement.
Should the failure occur on take-off, TOGA or FLEX thrust is maintained until thrust
reduction, after which maximum available thrust is MCT.

If the failure occurs when the thrust lever is between idle and MCT, FADEC will automatically
select the larger thrust lever angle, limited to MCT. On the ground, thrust is limited to idle.

In flight, keep the A/THR engaged (or engage A/THR if not in use) to allow it to manage
thrust between idle and the larger thrust lever angle position.
The FADEC will automatically set the thrust of the affected engine to idle when CONF 1 is
selected.

Note that reverse thrust is available for landing.

FAULT
If this fault develops, it indicates that a non-valid signal has been received from engine 1 or 2 thrust lever angle.
The fault on the ground freezes thrust to idle, and furthermore commands the reversers to stow.
In flight, keep the A/THR engaged (or engage A/THR if not in use) to allow it to manage thrust between idle and the larger thrust lever angle position. A/THR should be engaged before slat retraction. The FADEC will automatically set the thrust of the affected engine to idle when CONF 1 is selected.
Note that reverse thrust is NOT available for landing.

06 - COMPLETION STANDARDS
.
Maintains safe trajectory in all flight phases.

.
Ensures application of ECAM procedures, including specific approach requirements.

.
Respects task sharing procedures and ensures good crew communications.

07 - COMMON ERRORS
.
Different reason for "Disagree" and "Fault" not clearly understood.

.
Specific procedure not applied for approach.

A319/A320/A321 FLIGHT CREW TRAINING MANUAL  ABNORMAL OPERATION BRIEFINGS POWER PLANT  1.03.70  Page 10 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320/A321 FLIGHT CREW TRAINING MANUAL 機組訓練手冊(78)