1.
General ..............................................1
2.
Description and Operation ................................1
Section 32-10
Main Landing Gear
1.
General ..............................................1
2.
Description and Operation ................................1
Trouble-Shooting
1. General ............................................101
Maintenance Practices
1.
General ............................................201
2.
Remove/Install a Main Landing Gear Strut..................201
3.
Test/Adjust the Main Landing Gear .......................205
Section 32-20
Nose Landing Gear
1.
General ..............................................1
2.
Description and Operation ................................1
Trouble-Shooting
1. General ............................................101
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
32-CONTENTS
AMM
Maintenance Practices
1.
General ............................................201
2.
Remove/Install the Nose Landing Gear Strut ................201
3.
Remove/Install the Elastomer Pack .......................204
4.
Replace the Elastomer Elements.........................206
5.
Adjust the Nose Wheel Steering Friction ...................206
6.
Nose Wheel Balancing.................................207
Section 32-40
Wheels and Brakes
1.
General ..............................................1
2.
Description and Operation ................................1
Trouble-Shooting
1. General ............................................101
Maintenance Practices
1.
General ............................................201
2.
Remove/Install a Main Wheel ...........................201
3.
Remove/Install the Nose Wheel..........................203
4.
Remove/Install a Brake Master Cylinder ...................205
5.
Remove/Install a Brake Cylinder .........................207
6.
Remove/Install the Parking Brake Valve ...................209
7.
Bleed the Brake System................................211
8.
Condition the Brake Linings .............................213
Page 2 Doc # 6.02.01 09 Jan 2003 Rev. 4
32-CONTENTS
Landing Gear
AMM
CHAPTER 32
LANDING GEAR
1. General
The DA 40 has a fixed tricycle landing gear and a castering nose wheel. This Section gives you the general description and operation of the landing gear. See Section 32-10 for trouble shooting and maintenance practices for the main gear. See Section 32-20 for trouble shooting and maintenance practices for the nose gear. See Section 32-40 for trouble shooting and maintenance practices for the for the wheels and brakes.
Note: Equipment which is certified for installation in the DA 40 is listed in Section 6.5 of the Airplane Flight Manual. Such equipment may be installed in accordance with the Airplane Maintenance Manual.
Any equipment which is not listed in Section 6.5 of the Airplane Flight Manual is called "Additional Equipment". The installation of Additional Equipment is a modification which must be handled in accordance with national regulations or a Service Bulletin.
2. Description and Operation
Flat section steel leaf-springs make the main gear struts. Two mountings attach each main gear strut
% to the center section of the fuselage. The bottom of each strut has an axle, a brake torque plate and a mounting plate for the GFRP wheel fairing.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 3(74)
