曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

8. (8) If flying a non-HF equipped aircraft, is your route approved for VHF only? (See Chapter 4,
Flights Planning to Operate Without HF Communications, paragraph- 4.2.12.)
9. If flying other than on the special routes, are you sure that both your LRNSs are fully
operational?
NORTH ATLANTIC MNPSA OPERATIONS MANUAL CHAPTER 12
NAT MNPS 71 Edition 2009
10. Have you planned ahead for any actions you might need to take should you suffer a failure of
one LRNS? (See Chapter 10: Procedures in the Event of Navigation System Degradation or
Failure).
11. Are you sure that both your primary altimetry systems and at least one altitude alerter and one
autopilot are fully operational ?
12. Are you familiar with the required procedures for flight at RVSM levels? (See Chapter 9).
12.2.2 If, as a pilot, you have any doubt about your answers to these questions, it may be necessary
for you to consult with the Civil Aviation Department of your State of Registry.
12.3 SAMPLE NAT MNPS CHECK LIST
12.3.1 ICAO North Atlantic Working Groups composed of industry, ATC and state regulators have
created the following sample checklist. It is provided as guidance and is not intended to replace an
operator‟s oceanic checklist.. However, Operators without an oceanic checklist are encouraged to use this
sample and tailor it to their specific needs and approvals. This checklist focuses on an orderly flow and ways
to reduce oceanic errors. The detail of and the rationale for the proposed actions listed are described in the
“Expanded Check List” which follows on. Operators should use an oceanic check list as part of their Safety
Management System (SMS). Operators are also encouraged to study the “Oceanic Errors Safety Bulletin
(OESB)”. The OESB can be found at www.paris.icao.int/.
Check list proposals
Flight planning
- Plotting Chart – plot route from coast out to coast in
- Equal Time Points (ETP) - plot
- Track message (current copy available for all crossings)
- Note nearest tracks on plotting chart
- Review possible navigation aids for accuracy check prior to coast out
Preflight
- Master Clock for all ETAs/ATAs
- Maintenance Log – check for any navigation/ communication/surveillance or RVSM issues
- RVSM
- Altimeter checks (tolerance)
- Wind shear or turbulence forecast
- Computer Flight Plan (CFP) vs ICAO Flight Plan (check routing, fuel load, times,
groundspeeds)
- Dual Long Range NAV System (LRNS) for remote oceanic operations
- HF check (including SELCAL)
- Confirm Present Position coordinates (best source)
- Master CFP (symbols: O, V, \, X)
- LRNS programming
- Check currency and software version
- Independent verification
- Check expanded coordinates of waypoints
- Track and distance check (+ 2o and + 2 NM)
- Upload winds, if applicable
- Groundspeed check
NORTH ATLANTIC MNPSA OPERATIONS MANUAL CHAPTER 12
NAT MNPS 72 Edition 2009
Taxi and prior to take-off
- Groundspeed check
- Present Position check
Climb out
- Transition altitude – set altimeters to 29.92 in (1013.2 hPa)
- Manually compute ETAs above FL180
Prior to oceanic entry
- Gross error accuracy check – record results
- HF check, if not done during pre-flight
- Log on to CPDLC or ADS 15 to 45 minutes prior, if equipped
- Obtain oceanic clearance from appropriate clearance delivery
- Confirm and maintain correct Flight Level at oceanic boundary
- Confirm Flight Level, Mach and Route for crossing
- Advise ATC When Able Higher (WAH)
- Ensure aircraft performance capabilities for maintaining assigned altitude/assigned Mach
- Reclearance – update LRNS, CFP and plotting chart
- Check track and distance for new route
- Altimeter checks - record readings
- Compass heading check – record
After oceanic entry
- Squawk 2000 – 30 minutes after entry, if applicable
- Maintain assigned Mach, if applicable
- VHF radios-set to interplane and guard frequency
- Strategic Lateral Offset Procedures (SLOP) - SOP
- Hourly altimeter checks
Approaching Waypoints
- Confirm next latitude/longitude
Overhead waypoints
- Confirm aircraft transitions to next waypoint
- Check track and distance against Master CFP
- Confirm time to next waypoint
- Note: 3-minute or more change requires ATC notification
- Position report - fuel
10-minute plot (appr. 2° of longitude after waypoint)
- Record time and latitude/longitude on plotting chart – non steering LRNS
Midpoint
- Midway between waypoints compare winds from CFP, LRNS and upper millibar wind
charts
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：航空翻譯14(137)