-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION
-------------------------------------------------------------------------------
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
R 122VU AIR COND/PACK TEMP CTL SYS2/1/115VAC 2HH Y18
R **ON A/C 106-149, 303-399,
R 122VU 4HH Y19
R **ON A/C 401-499,
R R 122VU AIR COND/TEMP CTL SYS 1/CHAN A/115VAC 122VU AIR COND/TEMP CTL SYS 1/CHAN A/28VDC 122VU AIR COND/TEMP CTL SYS 1/CHAN B/115VAC 49HH 51HH 50HH X22 X21Y18
**ON A/C ALL
FOR 11HM5
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
122VU AIR COND/PACK TEMP/CTL SYS1/2/115VAC 122VU AIR COND/PACK TEMP/CTL SYS1/2/28VDC 122VU AIR COND/PACK TEMP CTL SYS2/2/28VDC 122VU AIR COND/PACK TEMP CTL SYS2/2/115VAC 21HH 23HH 24HH 22HH W22W21Y21Y20
R **ON A/C 401-499,
R R 122VU AIR COND/TEMP CTL SYS 2/CHAN A/115VAC 122VU AIR COND/TEMP CTL SYS 2/CHAN A/28VDC 122VU AIR COND/TEMP CTL SYS 2/CHAN B/28VDC 122VU AIR COND/TEMP CTL SYS 2/CHAN B/115VAC 53HH 55HH 56HH 54HH W22W21 Y21Y20
**ON A/C ALL
Subtask 21-52-22-010-050
C. Get Access
(1) Remove the access panel (Ref. TASK 53-35-13-000-002). FOR 10HM5 191KB, FOR 11HM5 192KB.
Subtask 21-52-22-941-050
D. Safety Precautions
(1)
On the panel 30VU:
(a)
Make sure that:
-
the APU BLEED pushbutton switch is in the off position (the ON legend is off) and,
-
the ENG 1 BLEED and the ENG 2 BLEED pushbutton switches are in the off position (the OFF legends are on).
(b)
Put a warning notice in position to tell persons not to operate these pushbutton switches.
(2)
On the HP ground connector put a warning notice in position to tell persons not to supply the ground air.
4. Procedure
_________
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
(Ref. Fig. 401/TASK 21-52-22-991-001) R **ON A/C 151-199, 401-499,
(Ref. Fig. 401A/TASK 21-52-22-991-001-A)
Fan Plenum Chamber 10HM5 (11HM5)
Figure 401/TASK 21-52-22-991-001
R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 21-52-22Page 405 1301-399, 1May 01/05 1 1 1CES 1
Fan Plenum Chamber 10HM5 (11HM5)
Figure 401A/TASK 21-52-22-991-001-A
R 1EFF : 151-199, 401-499, 1 21-52-22Page 406 1 1 Aug 01/05 1 1 1CES 1
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
Subtask 21-52-22-020-051
A. Removal of the Fan Plenum Chamber
(1)
Remove the ram air outlet/s (Ref. TASK 21-61-52-000-003).
(2)
Remove the pipe assembly/ies (Ref. TASK 21-52-23-000-001).
(3)
Remove the heat exchanger unit/s 10HM4 (11HM4) (Ref. TASK 21-52-24-000-001).
NOTE : It is not necessary to remove the inlet plenum at this time.
____
(4)
Remove the screws (1), the washers (2) and the fan plenum chamber (3).
(5)
Remove (where fitted) the gasket (4).
(6)
Put a protective cover on the cooling elements of the primary heat exchanger (5).
R **ON A/C 151-199, 401-499,
Subtask 21-52-22-020-051-A
A. Removal of the Fan Plenum Chamber
(1)
Remove the ram air outlet/s (Ref. TASK 21-61-52-000-003).
(2)
Remove the pipe assembly/ies (Ref. TASK 21-52-23-000-001).
(3)
Remove the heat exchanger unit/s 10HM4 (11HM4) (Ref. TASK 21-52-24-000-001).
NOTE : It is not necessary to remove the inlet plenum at this time.
____
(4) Bonding Strap Disconnection NOTE : This work step is only applicable for plenum chamber P/N
____
1816A0000-01
(a) Remove the nut (8), the washer (7), the screw (5) and disconnect the bonding strap (6).
(5)
Remove the screws (1), the washers (2) and the fan plenum chamber (3).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM AIR CONDITIONING 空調 4(47)
