曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  1. Reason for the Job__________________ 
R  Self Explanatory 
R  2. Job Set-up Information______________________ 
R  A. Referenced Information 
R  -------------------------------------------------------------------------------
R  REFERENCE  DESIGNATION 
R  -------------------------------------------------------------------------------
R  25-13-14-000-003  Removal of the Actuator on the Foot Rest Assembly 
R  25-13-14-991-009  Fig. 404 
R  3. Job Set-up__________ 
R  Subtask 25-13-14-840-050 
R  A. Preparation for the Removal 
R  (1) Remove the actuator on the foot rest assembly (Ref. TASK 25-13-14-
R  000-003). 
R  4. Procedure_________ 
R  (Ref. Fig. 404/TASK 25-13-14-991-009) 
R  Subtask 25-13-14-020-056 
R  A. Removal of the Captain and First-Officer Retractable Foot-Rests 
R  (1) Remove and discard the retaining rings (1). 
R  (2) Hold the retractable foot rest (3). 
R  (3) Remove the hinge pins (2). 
R  (4) Remove the retractable foot rest (3) from the foot rest and sliding 
R  table assembly (4).

 EFF : ALL

25-13-14Page 416
May 01/05

R R  Captain and First-Officer Retractable Foot-Rests Figure 404/TASK 25-13-14-991-009
 EFF :  ALL  25-13-14 Page 417 May 01/05
 CES 

 

R  TASK 25-13-14-400-005 
R  Installation of the Captain and First-Officer Retractable Foot-Rests 
R  1. Reason for the Job__________________ 
R  Self Explanatory 
R  2. Job Set-up Information______________________ 
R  A. Expendable Parts 
R  -------------------------------------------------------------------------------
R  FIG.ITEM  |DESIGNATION  |IPC-CSN 
R  -------------------------------------------------------------------------------
R  1  retaining rings  25-13-01 31E-060 
R  B. Referenced Information 
R  -------------------------------------------------------------------------------
R  REFERENCE  DESIGNATION 
R  -------------------------------------------------------------------------------

R  25-13-14-000-003  Removal of the Actuator on the Foot Rest Assembly 
R  25-13-14-400-003  Installation of the Actuator on the Foot Rest 
R  Assembly 
R  25-13-14-991-009  Fig. 404 
R  3. Job Set-up__________ 
R  Subtask 25-13-14-860-059 

R  A. Aircraft Maintenance Configuration 
R  (1) Make sure that the actuator on the foot rest assembly is removed 
R  (Ref. TASK 25-13-14-000-003).

 EFF : ALL

25-13-14Page 418
May 01/05

R  4. Procedure_________ 
R  (Ref. Fig. 404/TASK 25-13-14-991-009) 
R  Subtask 25-13-14-420-056 
R  A. Installation of the Captain and First-Officer Retractable Foot-Rests 
R  (1) Put the retractable foot rest (3) in position on the foot rest and 
R  sliding table assembly (4). 
R  (2) Install the hinge pin (2) through the hole of the retractable foot 
R  rest (3). 
R  (3) Safety the hinge pin (2)with a new retaining rings (1). 
R  5. Close-up________ 
R  Subtask 25-13-14-840-051 
R  A. Aircraft Maintenance Configuration 
R  (1) Install the actuator on the foot rest assembly (Ref. TASK 25-13-14-
R  400-003).

 EFF : ALL

25-13-14Page 419
May 01/05

 FOOT REST ASSEMBLY - INSPECTION/CHECK
_____________________________________
R **ON A/C 001-049, 051-061, 101-103, 201-203,
 TASK 25-13-14-200-001
 Detailed Visual Inspection of the Foot Rest Assembly
 1. Reason for the Job
__________________
R R Self Explanatory
 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
 the External Power 25-13-14-000-001 Removal of the Foot Rest and Sliding Table Assembly 25-13-14-400-001 Installation of the Foot Rest and Sliding Table
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備1(124)